menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

1757 results found for Hella Ireland

...Mazda 3 Model year: 07/01/2008-31/03/2009 Windscreen wiper fails If a complaint is made about the windscreen wiper failing in the above vehicle, this may indicate an insufficient earth connection in the windscreen wiper motor. In order to remedy this, an additional earth cable for...

...Mazda 3 (BL) 6 (GH) CX-7 (ER) Engine code: R2AA (2.2 MZR-CD) Cruise control not functioning, engine cuts out while moving If a complaint is made about the engine in the above vehicles cutting out while moving, this may indicate a defect in the camshaft sensor. In addition, the c...

...Mazda 3/6 series Engine code: PE, PY Year of construction: 10/2013 – 02/2014 Engine not running smoothly Engine stalls sporadically There have been complaints of unexpected engine stalling in the aforementioned vehicles. This may be due to a software error in the engine control unit...

...Mazda Mazda 5 Model year: 2010 to 2012 Noise coming from the centre air nozzles in the dashboard area With the above-mentioned vehicles, noises/vibrations can occur in the centre air nozzles in the dashboard area when the heating/air conditioning system is switched on. This effect is...

...2015 Mazda 6 (GH) Model year: 2008-2012 Engine will not start If the engine in the above vehicle will not start and the display remains dark, the reason may be a faulty earth connection (see marking, image 1). It is possible that the connection to the earth pin was not secured pro...

...Mazda 6 (GG/GY) Model year: 2002 - 2008 Engine: 2.0 Di Compressor malfunction If the compressor in one of the vehicles mentioned above malfunctions, the power supply to the magnetic clutch should be checked. The electrical cable for the magnetic clutch power supply (+) is routed to...

...Mazda Mazda 6 Model year: 2007 – 2012 All models Lighting up of the engine warning light. If complaints are made about the above-mentioned error and the engine goes into limp-home mode, the following fault codes could also be stored in the engine control unit. Fault code: - P0140...

...Mazda 626 IV (GE) Build year 1991-1998 with factory installed air-conditioning Leaking condenser On some of the above -mentioned vehicles a leakage on the condenser can occur. Often the leak is in the lower area. If a refrigerant loss is established, it`s recommended to spray this are...

...Mazda 626 IV (GE) Model year 1991 - 1998 With factory-fitted air conditioning system Air conditioning switch but no air conditioning system Since there is often confusion here, it must be stated that vehicles without an air conditioning system can have the same switch. The "air condit...

...Mazda 626 V (GF/GW) Engine: 2.0i 85KW High-pressure service connection The high-pressure service connection is attached to the filter/dryer of the above-mentioned vehicles. To save searching, please proceed as follows: • Remove the fixing plugs (Figur e 1, arrow) of the plastic cov...



...[Previous 10 pages] ... 72 | 73 | 74 | 75 | 76 | 77 | 78 | 79 | 80 | 81 ...[Next 10 of 176 pages] ...
footerlogo
popup