menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Headlamp power wash systems General information: According to legislation, a headlamp power wash system is compulsory in the case of vehicles with Xenon light. In the case of halogen light as well, these systems make sense for the following reason. The influenc...

...Technical Information Headlamps and lights Humidity To prevent the formation of humidity in headlamps and lights, the following notes should be considered: · When changing headlamps and lights the seals have to be replaced in the plug connections and servomotors Â...

...Technical Information Illegal Xenon retrofitting is dangerous and illegal Vehicle certification loses validity, insurance protection is restricted - up to 100 times higher glare values People who just buy a xenon headlamp set including cables, xenon light source and ballast, remove t...

...Technical information Daytime running lights Capillary action A rather unknown subject is the capillary action in lights. But more often than one might think this phenomenon is responsible for water penetrating into a light, accumulating inside. Capillary action describes the property of l...

...Technical Information LED daytime running lights Design and function Three Luxeon LEDs are used as the light source. These LEDs have a service life of more than 10,000 hours and are therefore particularly suited to continuous operation. In comparison with these, a 12V H7 headligh...

...LED (Light Emitting Diode) General points: LEDs are replacing conventional bulbs in more and more vehicles. The technical advantages such as smaller size, longer service life etc. mean that LEDs are being used in more and more areas of automotive technology. This information examin...

...Technical Information Modular LED Light General instructions The 55 mm light series (taillight, brake light, rear fog light, reversing light and indicator) have successfully established themselves in the market for years. Owing to new demands regarding function and design, this li...

...Additional Brake Light MS -Design rear spoiler The Hella brake light 2DA 005 739 -117 can be used as a replacement for the original in a ms -design rear spoiler, when this fail due to water ingression. Only the corners must be cut out, with a small hacksaw, to match with the o...

...Technical Information Receptacle for H1 und H7 bulbs Design and function The receptacles are equipped with two prefabricated cables and butt plugs. The butt plugs are suitable for cable diameters of up to 1 mm². However, the lengths of the cables are different. - The H1 socket has a...

...Technical Information Retrofitting daytime running light in vehicles with PWM signal When daytime running lights are retrofitted, the changeover relay included in the scope of supply can "vibrate" when the vehicle lighting is switched on. Since some vehicle manufacturers trigger the...



...[Previous 10 pages] ... 96 | 97 | 98 | 99 | 100 | 101 | 102 | 103 | 104 | 105 ...[Next 10 of 452 pages] ...
footerlogo
popup