menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Rover 600 Model year 1994 to 1999 No reduction in engine speed during gear change If there are complaints about the above-mentioned fault, the incorrect end stop of the accelerator pedal could be the cause. This could also lead to the following complaints: - Idling speed is too high....

...Rover 45 All models Chassis nos. RT471064 - RT506310 Failure of fuse no. 5 in the fuse box in the engine compartment. If there are complaints with these vehicles that fuse no. 5 in the fuse box in the engine compartment is burnt out, one possible cause is that the fuse inserted is not s...

...Rover 45 All models from model year 1999 Engine misfires and/or poor throttle response. If there are complaints with these vehicles that the engine misfires and/or shows a poor throttle response, one possible cause is a damaged cable to the ignition coils. Faulty installation of the upp...

...Rover 45 Condenser fan not working In the case of the above-mentioned vehicles, a non-working condenser fan can be the cause of faults and/or poor air conditioning system cooling performance. It is often established that t he radiator fan works in an uncontrolled manner, with cons tant...

...Rover 45 model year 1999 to 2004 Engine backfires If there are complaints about the above-mentioned fault, incorrect routing of the coil wiring harness could be the cause. Apart from backfiring, the fault could also become noticeable due to delayed throttle response. This situation oc...

...Rover 200 Model years 1995-1999 With engines from the K and T series Engine doesn't start up or continues to run when the ignition has been switched off. If there are complaints with these vehicles that the engine does not start up or continues to run after the ignition has been switch...

...Rover 200 All models Deactivation of the alarm control system/immobilizer not possible via the remote control. If there are complaints with these vehicles that the alarm control system/immobilizer cannot be deactivated vi a the remote control, the following causes should be conside...

...CT 1096 K1 timing belt kit taking as an example: Rover / MG all 2.0 / 2.5 V6 Power Transmission Group Automotive Aftermarket ContiTech Antriebssysteme GmbH Philipsbornstraße 1, D-30165 Hannover Techn. Hotline +49 (0)511 938 -5178 E-mail: frank.wissbroecker@ptg.contitech.de www.contitech...

...Small but significant - Rough when cold Ford Fiesta Ecoboost 1.0 M1DA This Fiesta had been in the workshop many times over a few months, for a rough running issue when the engine was cold. After a warmup period, the engine returned to perfect running and no codes were present. While all...

...Technical Information Rota LED beacon Product features Installation information During installation of the fixed body variant make sure that the cables passage to the Interior is sealed. This can be done, for example, with a suitable rubber...



...[Previous 10 pages] ... 97 | 98 | 99 | 100 | 101 | 102 | 103 | 104 | 105 | 106 ...[Next 10 of 452 pages] ...
footerlogo
popup