menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Inlet Air Temperature (IAT) Sensor General IAT sensors sense the air temperature on the inlet side of the engine. The voltage signal, produced by the sensor, is passed to the ECU. The ECU evaluates the signal and influences the fuel injection timing and ignition t...

...Technical Information Knock Sensor General You can find the knock sensor mounted on the side \ of the engine block. It recognises knock or pinging under all engine operating conditions to avoid lack of performance....

...Technical Information Lambda sensor General Due to the increasing strictness of exhaust emission regulations, the vehicle manufacturers are committed to reducing their vehicle emissions. For this reason a 3-way catalytic converter is fitted to nearly all vehicles. To achieve a good conv...

...Technical Information Zirconium dioxide lambda sensor (spring sensor) Manufacturer-specific cable colours The following different cable colours may be used f or the above-mentioned lambda sensors: Manufacturer Hella Bosch Delphi Denso Toyota Signal cable black black pu...

...Technical Information Failure control with LED indicators General points In the case of vehicles approved for use on public roads, the indicators must be monitored. The failure of an indicator must be shown optically or acoustically in the vehicle. This applies in all ECE states. The m...

...Technical Information Level control switch for engine oil General Oil level control switches are fitted in the oil sump. They records the minimum oil level and send a signal to the ECU when there is an engine oil shortage. The ECU activate the warning system, a warning light or...

...Technical Information Level switch for windshield washer General The windshield washer switch records the low washer fluid level. They prevent a failure through water shortage. Function A magnet fitted in a float sinks when the washer fluid level is dropping and...

...Technical Information Manifold air pressure sensor (MAP) General The manifold air pressure sensor measures the vacuum in the induction pipe after the throttle valve. The readings taken by the MAP sensor and the intake air sensor are used to compute the volume of air intake. The result...

...Technical Information Hella Rear View Camera System-System General The system camera is based on a module which was developed by Hella for use in the original-equipment sector and which is used in the case of the Chrysler Pacific a. A housing has now been developed for this camera...

...Technical Information Exchanging the rain/light sensor using a silicone repair set General information Increasingly, rain/light sensors are fitted to the windscreens of modern cars. If it is necessary to replace the windscreen, the question of how to deal with these sensors there...



...[Previous 10 pages] ... 123 | 124 | 125 | 126 | 127 | 128 | 129 | 130 | 131 | 132 ...[Next 10 of 452 pages] ...
footerlogo
popup