menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Sun sensor General One of the sensors that is part of nearly every climate control unit nowadays is the sun sensor. Mostly located on top of the dashboard near the windscreen (picture 1). The sun sensor (picture 2) measures the suns`s radiation and heat which causes the vehicles interior...

...Technical Information Refrigerant analysis devices Impure and/or combustible refrigerants can result in a number of hazards: • Damage or soiling of air conditioning components and service units. • Soiling of refrigerant bottles by so-called "drop ins" for example (refrigerant mi...

...Technical Information Tube connector (Vulkan-Lokring) Again and again, tubes and connections become damaged due to vibration or on account of non-professional routing. Usually these tubes are replaced by new ones. It is not absolutely necessary to fall back on original tubes which ar...

...Universal pressure switch set General This pressure switch set is specially constructed for universal fitting to all systems (pressure switch connections with an outside thread 3/8”- 24UNF or ¼”) . The switch points are 2,1 / 17,5 / 24 bar. Contents of the pressure swi...

...Technical Information Visco clutch General points The Visco clutch is part of the Visco fan. If has the task of creating the frictional connection between the drive and the fan wheel depending on temperature, and thus influencing its speed. There is a plastic fan attached to the clutch...

...Technical Information Visco fan General points For heat dissipation in truck and powerful car engines, fans and fan drives which provide cooling air particularly efficiently are required in addition to powerful coolers. Visco fans (Fig. 1) are made up of a fan wheel and a Visco clutch....

...Technical Information Toothed belt / coolant pump kits General When replacing the toothed belt, all components of the belt drive should be replaced with it. For this purpose, Behr Hella Service offers complete kits (Fig. 1) including coolant pump, toothed belt, as well as any tens...

...Q2 / 2014 Brake calliper with integrated handbrake mechanism Assembly note for replacement brake callipers General installation note Handbrake callipers are usually set or adjusted so that the distance between the brake lining and the brake disc is at least (X) + 1 mm (fig. 1). I...

...Brake disk General information Since the introduction of the disk braking system to the automobile, it has become a key structural component in automotive engineering. Together with the brake lining, the brake disk forms a friction couple which is subject to wear and tear and must be...

...Brake discs with wheel bearing and impulse ring General information As a result of the extreme variety of axle constructions produced by all the different car manufacturers, wheel bearings and impulse rings of the anti-lock braking system (ABS) are also integrated into the brake discs...



...[Previous 10 pages] ... 124 | 125 | 126 | 127 | 128 | 129 | 130 | 131 | 132 | 133 ...[Next 10 of 452 pages] ...
footerlogo
popup