menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Starter overrun Damage Overrun starters can be recognized via tarnishing o n the one-way clutch/pinion, traces of scuffing on the armature shaft, an ejected commutator/armature winding and/or burning of the coil of the solenoid switch. Causes The ca...

...Technical Information Starter Fault diagnosis Electrical faults in the starter can mostly to be put down to an overload ed. This can be due to short -circuits to earth in field and rotor winding, but sometimes also in the winding of the control components (solenoid switch...

...Technical Information Starters with different numbers of teeth Within the framework of daily garage work, it may be that again and again starters with different numbers of teeth must be fitted. Within the framework of product revisions, it may well be possible that starters with diff...

...Technical Information Damage to starters with ferrite magnets General In the case of some starter types, the field windings made of copper or aluminium are replaced by ferrite magnets. Damage Damage that often occurs in the case of these starter types is broken ferrite magnets....

...Technical Information Troubleshooting Earth (31) – often ignored Loose or oxidised earth connections lead to malfunctions on electric and electronic components again and again. Particularly affected are the areas outside the vehicle interior such as: alternator, starter, batter...

...Technical Information Evaporation loss - and re - circulation system / absorption canister General In a parked vehicle, fuel evaporates via the tank vent line into the environment. To avoid this pollution, vehicles with a controlled fuel mixture system, have an evaporation lo...

...Technical Information Accelerator pedal position sensor General On modern vehicles the percentage of electronic components is increasing. Reasons for this, are among others, the legal regulations, e.g. emissions and fuel consumption reduction, the increase of active and passive safet...

...Technical Information Air Flow Sensor (MAF) General The air flow sensor records the incoming air flow. It is constructed of a duct style housing with a flow rectifier, sensor protection and a sensor module. The air flow sensor is fitted into the inlet pipe between the air filte...

...Technical Information Delivery quality of optical bodies for light control units and rain/light sensors In some optical bodies for the light control unit and the rain/light sensors, there may be air bubbles in the adhesive pad. This applies to the following variants: Th...

...Technical Information Camshaft sensor General Camshaft sensors have the function, in coordination with the crankshaft sensor, to define N o 1 cylinder compression/firing stroke. This information is needed for a) commencement of injection on sequential injections system, b) th...



...[Previous 10 pages] ... 128 | 129 | 130 | 131 | 132 | 133 | 134 | 135 | 136 | 137 ...[Next 10 of 452 pages] ...
footerlogo
popup