4511 results

• 
• Type

  Technical Bulletin

• Problems/Recalls on Micra Push Button Start

• Aug 16

• Autoelectro (21)
• 

...You think it would be safe to assume that replacing the conventional ignition switch with a push button start, you would avoid issues with the switch failing and the starter motor remaining engaged due to continuous power supplied to the solenoid. Well that is not the case when it comes...

• 
• Type

  Technical Bulletin

• Problems with the installation of the OC 248 spin-on oil filter

• Jul 23

• MAHLE (144)
• 

...Technical Messenger 06|2023 Problems with the installation of the OC 248 spin-on oil filter When converting a minibus into a camper and adding an additional oil cooler, the oil filter area can become tight and complicated. The new oil cooler might interfere with feed and return lines, oil...

• 
• Type

  Technical Bulletin

• Problems with Electrical EGR Valves on Opel/Vauxhall

• Feb 10

• Pierburg (204)
• 

...© MS Motor Service International GmbH – 0109 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKolbenschmidt Pierburg grou PS E R V I C EIN f o r Ma t Io NSI 0082/AElectrical EGR-valve (Opel/Vauxhall)Adhesions/coke deposits on the valvesVehicle...

• 
• Type

  Tech Tip

• Problems Starting a 2.4D Transit?

• May 13

• Valeo (135)
• 

...Problems Starting a 2.4D Transit? Valeo technical have received a number of calls regarding an issue with Ford Transit 2.4 diesels, that are not starting once a conversion clutch and flywheel kit has been fitted. Here are some of the common problems that they have found, with a remedy for...

• 
• Type

  Tech Tip

• Problems from poor fuel quality

• Jan 19

• Autoinform (109) Contact
• 

...Problems from poor fuel quality Ahead of the Autoinform Live training event in Cork in April, Frank Massey wants to get you thinking about problems you are facing in your own garage. This month Frank discusses fuel quality, and how it can be the cause of some failures and poor running pro...

• 
• Type

  Installation Instructions

• Problems following a filter change?

• Aug 13

• MAHLE (144)
• 

...If the engine does not start or fuel leaks occur following a filter change, the cause is often to be found in the fi lter being incorrectly fitted. IMPORTANT: THE CORRECT FITTING ORDER OF THE SEAL AND FILTER ELEMENT TO THE HOUSING AND COVER. If fitted the wrong way round, leaks will...

• 
• Type

  Technical Bulletin

• Problems Caused by Belt Slip

• May 15

• Gates (127) Contact
• 

...Serpentine System – Problems with Belt Slip Accessory belt drive alternator problem from belt slipping worn tensioner worn damper...

• 
• Type

  Technical Bulletin

• Problems after Installing Intake Manifold Servo Motor

• Aug 20

• Pierburg (204)
• 

...INTAKE MANIFOLD SERVO MOTOR:PROBLEMS AFTER INSTALLATION Potential complaints:• Repeated malfunctions following installation of a new servo motor• Fluctuations in speed and jerking• Diagnostic trouble codes P1018, P208, P2011, P3135 DO NOT FORGET TEACHING-IN! Electric servo motors (01...

• 
• Type

  Technical Bulletin

• Problem with Timing Chain Kit and Camshaft Bracket

• May 20

• febi (170)
• 

...PROTIPS Technical data can be subject to change Ferdinand Bilstein GmbH + Co. KG Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. +49 2333 911-0 | www.bilsteingroup.com EN To fit: Volkswagen, Audi, Seat & Skoda various models febi 45956 102196, 102426, 106512, 106513, 171970, 1720...

• 
• Type

  Technical Bulletin

• Problem fitting Oil filter with sealing ring

• Jun 23

• Blue Print (202) Contact
• 

...Problem fitting Oil filter with sealing ring Blue Print ADF122102, ADG05527 To fit: various Citroën, DS, Fiat, Ford, Jaguar, Lancia, Land Rover, MINI, Mitsubishi, Opel, Peugeot, Toyota, Vauxhall and Volvo models Problem When trying to replace the oil filter element ther...