menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

  • img
  • Type

    Tech Tip

  • Alternator diagnostics for Opel with Isuzu Engines
  • Apr 14

  • Blue Print (202) Contact
  • PDF

...There are some common faults associated with the charging system on Opel applications using the Isuzu 1.5 and 1.7 diesel engines. Blue Print gives some pointers to correctly diagnosis charging system faults prior to replacing the alternator, and to assist in the prevention of further probl...

...Technical MessengerWorkshop InformationIssue No. 06/2017: Alternator failure due to oil ingresswww.mahle-aftermarket.comFigure 1: Oil residue in the alternatorFigure 2: Heavy wear on the slip rings (left) and carbon brushes (right) Figure 3: Depending on the installation position, it is i...

...Alternator not working Technical MessengerWorkshop InformationIssue no. 04/2018: Alternator not workingwww.mahle-aftermarket.comIMPORTANT: Always interrupt the electrical circuit (disconnect the battery earthing cable) before performing any work on the alternator. Labeling the connections...

  • img
  • Type

    Service Information

  • Alternator OAP - Features and Benefits
  • Jun 11

  • Gates (127) Contact
  • Video

...Did you know that some solid alternator pulleys have been replaced by a patented pulley technology that is an important part of the drive system design? These new high tech alternator decoupler pulleys (ADP) allow the belt to power the alternator during acceleration and cruising speed, but...

...THIS BULLETIN ONLY APPLIES IF YOU HAVE THE FOLLOWING 3-PIN STRIP PLUG ON THE ALTERNATOR: A known fault exists which can result in a charging fault. This can be the alternator showing as overcharging and/or charging with the warning light on. This alternator is operated through a sma...

  • img
  • Type

    Technical Bulletin

  • Alternator overrunning pulley problem on Mazda
  • Jun 23

  • Blue Print (202) Contact
  • PDF

...Blue Print ProTip ADM561302 Alternator overrun pulley To fit: Mazda CX-30, CX-3, CX5 I & II, Mazda 2 III, Mazda 6 III & IV Engines: 1.5d, 1.8, 2.2d Problem The vehicle becomes difficult to start and displays signs of overheating, and/or there is a ‘squealing’ noise from th...

...Alternator pulley/bearing failure caused by water contamination on crankshaft pulley Ford Transit 2.2TDCi 2006-2012 Part Number affected: AEK2977 A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt...

...This fault is found on Ford Transits with 2.2TDCi engines from 2006 to 2012 (Alternator Part No. AEK2977) A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt contaminating the crankshaft pulley and causin...

...Technical MessengerWorkshop InformationIssue no. 08/2016: Shaft separation in alternatorswww.mahle-aftermarket.comFigure 1: Separated threadFigure 2: Impact drivers are only used to loosen the pulley, NEVER to tighten it!Figure 3: Always use a hold-down tool and torque spanner to tighten t...

...Alternator/Starter Failure Caused by Fuel and Water Ingress The number of failures caused due to fluid contamination is rising. Many applications now have starter motors and alternators installed under or around some form of lubricant/fluid component or pipes. Fuel filters, power steering...



...[Previous 10 pages] ... 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 ...[Next 10 of 452 pages] ...