4511 results

• 
• Type

  Technical Bulletin

• Fuel systems

• Aug 11

• Gates (127) Contact
• 

...There has been a big evolution in car fuel technology: pressures have gone a lot higher, fuel permeation is legally controlled and there are numerous different fuel blends. These blends have chemical compositions which can damage the rubber of standard fuel hoses , plastic seals and no...

• 
• Type

  Technical Bulletin

• Idler for Fiat,/Opel 1.9/2.0 Diesel

• Jul 15

• Gates (127) Contact
• 

...The idler T42140 ( Fig.1 and Fig.2) is used in many engines but the threaded engine installation hole may differ in size. The Gates idler is supplied with a M8 bolt that has a 10mm shaft and a washer. Some applications require an M10 . If so the original bolt can be re -used...

• 
• Type

  Technical Bulletin

• Hyundai, Kia 1.5, 2.0 & 2.2 D Tenioner

• Jul 15

• Gates (127) Contact
• 

...E2/TT005 v1.0 › 12/2014 › Pag. 1/1 Tensioner T43133 has a very particular installation process , described below . Removing the load pin too early influences the working area of the tensioner dramatically and leads to premature failure with engine damage as a consequence. T431...

• 
• Type

  Technical Bulletin

• VAG 1.6 Diesel: CAYB & CAYC + Air-conditioning

• Jul 15

• Gates (127) Contact
• 

...E2/TT006 v1.0 › 12 /2014 › Pag. 1/1 Changes to VAG 1.6 diesel CAYB & CAYC engines affect models equipped with air conditioning , from October 2009 on ward. Classic Multi- Ribbed V-belts replace earlier elastic belts. 6PK1140SF – 6PK1070+T38427 VAG 1.6 Diesel: CAYB & CAYC +...

• 
• Type

  Technical Bulletin

• 6PK1249SF – 6P K1305 +T38318

• Jul 15

• Gates (127) Contact
• 

...E2/TT00 7 v1.0 › 12 /2014 › Pag. 1/1 The 6PK1249SF is a ' stretch' belt used by Ford and Volvo for various petrol and bi -fuel engines (see catalogue for details ). It replaced a standard multi -ribbed belt with tensioner combination for cars manufactured from November 200...

• 
• Type

  Technical Bulletin

• Opel 1.4 Petrol OAPs

• Jul 15

• Gates (127) Contact
• 

...E2/TT00 9 v1.0 › 12 /2014 › Pag. 1/1 On certain Opel/Vauxhall engines ( codes: A14NEL, A14NET, A14XEL, A14XER) the belts may have 5 or 6 ribs while the pulleys may have 5 or 6 grooves . It depends on the manufacturing date of the car . Gates recommends replacement of a 5 groo...

• 
• Type

  Technical Bulletin

• VAG 1.8 Petrol Tensioner

• Jul 15

• Gates (127) Contact
• 

...E2/TT010 v1.0 › 12 /2014 › Pag. 1/1 Tensioners T43016 (Fig. 2) and T43017 (Fig. 1) are used in combination with Timing Belt 5491XS. Although both tensioners look identical at first sight, they are not interchangeable. The difference is to be found in the orientation of the a...

• 
• Type

  Technical Bulletin

• Honda Accord and FR-V 2.2 CDTi Pulley Modification

• Jan 16

• Autoelectro (21)
• 

...Certain Honda vehicles have a known fault in the drive belt system that results in the premature failure of the alternator pulley and/or bearings.These are: Accord 2.2 CDTi 2004-2008 FR-V 2.2 CDTi 2005-2010 with Honda Engine Codes: i-CDTI N22A1 2004-2011 Some of the vehicles are ori...

• 
• Type

  Technical Bulletin

• Brake caliper retaining spring - General, Task and function, Mounting instructions

• Nov 15

• Hella Ireland (1757)
• 

...Brake caliper retaining spring General The disk brake can only be guaranteed to function reliably if every component does its job properly. As such, the brake caliper retaining spring must be examined carefully. Task and function The retaining spring's job is to hold the brake...

• 
• Type

  Technical Bulletin

• Brake hoses and brake lines

• Jan 16

• Hella Ireland (1757)
• 

...Brake hoses and brake lines General information In hydraulic brake systems, brake hoses and brake lines are used to transfer brake fluid. Brake lines connect the actuation device, such as the brake master cylinder, to the hydraulic components of the wheel brake. Brake hoses are used a...