4511 results

• 
• Type

  Technical Bulletin

• Mazda RX-8 - Coolant level warning light on

• Jul 14

• Hella Ireland (1757)
• 

...Mazda RX-8 All models from 10/2008 onwards Lighting up of the coolant level warning light If the coolant level warning light comes on in the above-mentioned vehicles although the coolant level is correct, a possible cause of the trouble is a faulty coolant level sensor. In such case...

• 
• Type

  Technical Bulletin

• Mazda MX-5 (Typ: NA+NB) - Ignition wire

• Sep 01

• Hella Ireland (1757)
• 

...Mazda MX-5 (Typ: NA+NB) Ignition wire The ignition wires directly fixed to the engine block, are often the cause of the following faults: · misfire · poor low end pull · unsatisfactory power · irregular idle · higher fuel consumption · radio interfere...

• 
• Type

  Technical Bulletin

• Mazda Mazda 3 - Poor running engine

• Sep 14

• Hella Ireland (1757)
• 

...Mazda Mazda 3 All models with the MZR-CD engine code (RF-Turbo) Poorly running engine. If complaints are made about the above-mentioned problem, the trouble could be traced back to a faulty fuel pressure regulator control solenoid valve. The following complaints can also be included...

• 
• Type

  Technical Bulletin

• Mazda Ignition Coil Problem

• Nov 23

• Blue Print (202) Contact
• 

...Ignition Coil- for various Mazda models Problem Vehicle symptoms include a lack of engine power and an inconsistent idle, combined with the engine malfunction indicator lamp being illuminated on the instrument cluster. Engine Control Unit (ECU) diagnostics will reveal the following po...

• 
• Type

  Technical Bulletin

• Mazda and Ford Timing Alignment Pin Set ADM55501

• Mar 11

• Blue Print (202) Contact
• 

...Product Information: ADM55501 Timing Alignment Pin Set Applications: Multiple Mazda and Ford models fitted with 1.4TDCi and 1.6TDCi engines Blue Print’s ‘Timing Alignment Pin Set’ ADM55501 is required to allow correct  engine timing alignment which is vital when...

• 
• Type

  Technical Bulletin

• Mazda 626 V - High-pressure service connection

• Aug 04

• Hella Ireland (1757)
• 

...Mazda 626 V (GF/GW) Engine: 2.0i 85KW High-pressure service connection The high-pressure service connection is attached to the filter/dryer of the above-mentioned vehicles. To save searching, please proceed as follows: • Remove the fixing plugs (Figur e 1, arrow) of the plastic cov...

• 
• Type

  Technical Bulletin

• Mazda 626 IV - Air-conditioning switch but no air-conditioning

• Jun 04

• Hella Ireland (1757)
• 

...Mazda 626 IV (GE) Model year 1991 - 1998 With factory-fitted air conditioning system Air conditioning switch but no air conditioning system Since there is often confusion here, it must be stated that vehicles without an air conditioning system can have the same switch. The "air condit...

• 
• Type

  Technical Bulletin

• Mazda 626 IV - Leaking condenser

• Aug 03

• Hella Ireland (1757)
• 

...Mazda 626 IV (GE) Build year 1991-1998 with factory installed air-conditioning Leaking condenser On some of the above -mentioned vehicles a leakage on the condenser can occur. Often the leak is in the lower area. If a refrigerant loss is established, it`s recommended to spray this are...

• 
• Type

  Installation Instructions

• Mazda 6, 323, 626, Premacy Rear Brake Caliper Fitment Guide

• Nov 01

• Blue Print (202) Contact
• 

...Blue Print brake calipers are supplied pre-set to fit with new brake pads and discs without adjustment. If disc or pad wear has taken place (or the piston is retracted during fitment), MANUALLY ADJUST THE PISTON TO WITHIN 1MM OF THE PADS. If the piston is forced to adjust further than 1mm...

• 
• Type

  Technical Bulletin

• Mazda 6 Boot cover

• Sep 12

• Blue Print (202) Contact
• 

...Mazda 6 Estate Luggage Cover Repair Kit Applicable References: ADM58067 Applications: Mazda 6 Estate 2002>2008 The retracting mechanism on the Mazda 6 estate luggage cover commonly fails, resulting in a cover that no longer returns back into its housing. The failing component is a pl...