4511 results

• 
• Type

  Installation Instructions

• Front Shock Installation VW, SEAT and SKODA

• Dec 14

• KYB (115)
• 

...Video to show correct fitment of shock absorbers to FRONT of: AUDI A3/A3 Sportback (05.03-) SEAT Leon II (05.05-); Alhambra II (06.10-); Altea/Altea XL (03.04-); Toledo III (04.04-05.09 SKODA Superb (03.08-), Yeti (05.09-), Octavia II / Octavia II Combi (02.04-02.13) VW Passat CC (05...

• 
• Type

  Technical Bulletin

• DMF for VAG vehicles with a double clutch

• Dec 14

• LuK (131) Contact
• 

...DMF for vehicles with a double clutch Note the number of teeth on the starter ring during replacementManufacturer: Audi Seat ŠKODA Volk swagenTransmission: 0AM LuK DMF: 415 0509 09 415 0531 09 415 0545 09 415 0626 09Image 1: The number of teeth on the starter ring of the...

• 
• Type

  Technical Bulletin

• Different VAG DMF designs

• Dec 14

• LuK (131) Contact
• 

...Different DMF designs Distinguishing features by manufacturerManufacturer: Audi Seat ŠKODA VolkswagenImage 1: LuK DMF with bead on outer radiusVehicles from the manufacturers listed above may be fitted with clutch/dual mass flywheel (DMF ) combinations from either LuK or SACHS. These...

• 
• Type

  Technical Bulletin

• Clutch disc with new first stage damper

• Dec 14

• LuK (131) Contact
• 

...Clutch disc with new first stage damper Six spring torsional damper with first stage damper for higher capacitySix spring damper with first stage damperIn addition to transmitting engine torque, the clutch disc has the task of preventing torsional engine vibrations from reaching the powe...

• 
• Type

  Technical Bulletin

• Lubricating clutch release systems

• Dec 14

• LuK (131) Contact
• 

...Note:To avoid mistakes when selecting a lubricant,Castrol Olista Longtime is recommended.Greasing of the release system The release bearings and guide sleeve do not always need greasingImage 1: Release bearings with a plastic sliding sleeve must not be greasedA well functioning clutch sys...

• 
• Type

  Technical Bulletin

• Clutch grabs when shunting

• Dec 14

• LuK (131) Contact
• 

...Setting the clutch booster is only necessary if either the clutch pressure plate, clutch disc or piston rod has been replaced. A suitable diagnostic device is required for working on or adjusting the transmission control.Clutch grabs when shunting Manufacturer: Mercedes-BenzModels: Actr...

• 
• Type

  Technical Bulletin

• Mercedes Actros Grabbing clutch

• Dec 14

• LuK (131) Contact
• 

...Grabbing clutch Possibly caused by incorrect adjustment of the clutch boosterFabricante: Mercedes-BenzModelos: Actros MP 2 (2003 -2008) Actros MP 3 (2008 - )Tipo: 932, 933, 934 with code (GE2) EDC II (Electronic Drive Control) 930, 932, 933, 934, 940, 944 with code GE3 Mer...

• 
• Type

  Installation Instructions

• Timing Belt Installation on a Volkswagen Jetta

• Dec 14

• Dayco (52)
• 

...How to Replace a Timing Belt on a Volkswagen Jetta This video shows the proper way to replace a timing belt on a Volkswagen Jetta. In this instance, Dayco replaced the timing belt on a 2004 VW Jetta with a 1.9 liter TDI 4-cylinder diesel engine. We replaced the timing belt and component...

• 
• Type

  Technical Bulletin

• Renault Laguna 1.9 dci Timing Belt Installation

• Dec 14

• Dayco (52)
• 

...Timing kit installation - Renault Laguna 1.9 dci Diesel F9Q 750 Timing kit installation. Timing belt and water pump replacement. Vehicle used as example for the KTBWP4650 kit installation: Renault Laguna II 1.9 dci....

• 
• Type

  Technical Bulletin

• Seat and Volkswagen Incorrect Fuel Gauge Reading

• Dec 14

• Pierburg (204)
• 

...Seat and Volkswagen Incorrect Fuel Gauge Reading Seat and VW Incorrect Fuel Gauge Reading SI 0094/Awww.ms-motorservice.com© MS Motorservice International GmbH – 12/14 ENThe right of changes and deviating pictures is reserved. For assignment and replacement parts, refer to the curr...