4511 results

• 
• Type

  Technical Bulletin

• Mis-matched pair of DRL's Causing Problem

• May 23

• Autobiz (337)
• 

...On a mis-matched pair of DRLs small details really did matterA vehicle was presented for its first NCT test, and the front side lights were not operational. The workshop checked the 501 bulbs in both headlights, and they were not blown. The vehicle was scanned for codes, and it came bac...

• 
• Type

  Technical Bulletin

• Misalignment of diaphragm spring fingers

• Jul 15

• LuK (131) Contact
• 

...Misalignment of diaphragm spring fingersManufacturers: PSA/Peugeot, Citroën LuK RepSet: 623 3325 00 623 3325 09 623 3325 33 601 0021 00Fig. 1: Misalignment of diaphragm spring fingers on a dismantled clutchThe diaphragm spring fingers of the pressure plate in the LuK RepSet are m...

• 
• Type

  Technical Bulletin

• Misfire Diagnosis and Cylinder Balance Testing Using an Oscilloscope

• Jun 15

• PicoScope (102)
• 

...Misfire Diagnosis and Cylinder Balance Testing Using an Oscilloscope PicoDiagnostics software can be used to quickly test the relative power output (power balance) and count the number of misfires from each cylinder. This can rapidly show problems such as power loss due to ignition iss...

• 
• Type

  Technical Bulletin

• Misfiring Renault Modus

• Dec 23

• Autobiz (337)
• 

...The owner of this 2007 Renault Modus 1.6 was not budgeting for any problems, and so was pretty upset when she came to see me. The little Modus was not aware that it was supposed to be behaving and had begun to develop a little hiccup now and again. The owner had ignored it at first, but no...

• 
• Type

  Technical Bulletin

• Mitsubishi 1.8 GDI, Volvo V40/ S40 1.8 Idler Pullet Overheating

• Jun 09

• Contitech (157)
• 

...Failure of the idler pulley from CT 941K1 due to overheating Mitsubishi 1.8 GDI, Volvo V40/ S40 1.8 Power Transmission Group Automotive Aftermarket ContiTech Antriebssysteme GmbH Philipsbornstraße 1, 30165 Hanover, Germany Techn. Hotline +49 (0)511 938 -5178 E-mail: frank.wissbroecker...

• 
• Type

  Technical Bulletin

• Mitsubishi 4D56T 16V Engine Head Gasket Modification

• Jan 17

• FAI (38)
• 

...faiauto.comHG2101 uses latest OE modification.Mitsubishi 4D56T 16V Engines Following OE modification, FAI now offers the latest design head gasket for Mitsubishi 4D56T 16V engines. The new design has a corrugated upper surface and smooth profile lower layer, completely matching OE. This g...

• 
• Type

  Technical Bulletin

• Mitsubishi 4M4 Head Gaskets

• Jul 18

• FAI (38)
• 

...faiauto.comHG1539 vs. HG2258Mitsubishi 4M4# Head Gaskets Similarity in gaskets can easily lead to fitment and performance issues. The two gaskets below are a case in point, both fit Mitsubishi four cylinder common rail 4M4# generation engines. However HG1539 fits the earlier 3.2 (4M41) eng...

• 
• Type

  Technical Bulletin

• Mitsubishi 4M41 Diesel Engine Timing Chain Kit

• Aug 23

• febi (170)
• 

...febi 102440,107345 Timing chain kit To Fit: Mitsubishi Montero, Pajero and Shogun models fitted with 4M41 diesel engine. Problem A rattling noise coming from the engine timing chain area or a broken timing chain. Cause The timing chain tensioner’s wear is accelerated...

• 
• Type

  Tech Tip

• Mitsubishi AYC/ACD system

• Aug 13

• Blue Print (202) Contact
• 

...Mitsubishi AYC/ACD system Written by Jim gilmour Blue Print’s Technical Consultant. electronic stability programmes by any other name have been around for over a decade and have contributed greatly to vehicle safety. Much has been written about them, and for the most part, their op...

• 
• Type

  Technical Bulletin

• Mitsubishi Clutch Replacment - Mainshaft Flywheel (Spigot) Bearing Failure

• May 06

• Blue Print (202) Contact
• 

...We have encountered several cases of flywheel (spigot) bearing failure on some Mitsubishi models. The flywheel should be carefully checked or replaced when installing a new clutch assembly. The following points should be noted during routine clutch replacements: A seized flywheel bearing m...