menu

Search 4,572 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4563 results

...Various BMW & VAG Group Vehicles Ball Race Release Bearings Which Appear To Have A Plastic Contact Face Concerns; We have had several instances now of garages querying if the plastic face is just for protection and should it be removed prior to fitting Method; Under no circumstances sho...

...The Use of Clutch Assembly Grease Concerns; Borg&Beck are receiving warranties for various faults caused by the use of excess clutch grease and/or the use of an incorrect grease type (eg;copper based and LM grease’s) during clutch installation. One example of the problems we have seen i...

...Cover Assemblies “AS” Type Displaced Release Lever Struts recommendations should be followed, failure to observe them could result in a strut becoming dislodged.After the clutch is fitted to the flywheel, under no circumstances must a release lever, or the release lever plate if fitte...

  • img
  • Type

    Technical Bulletin

  • BMW Mini Clutch Kit

  • Jan 13

  • Blue Print (205) Contact
  • PDF

...INF136 BMW Mini Clutch Kit BMW Mini Clutch Kit Replacement Applications: BMW Mini 1.4DT/1.6i 2001-2006 Applicable References: ADG030148 / ADG030149 / ADG030150 We have had reports of clearance and gear selection problems for the BMW Mini 1.4DT/1.6i 2001-2006. Repairers understandably a...

...Installing the water level sensor in diesel fuel filters KL418, KL431, KL581 Some fuel fi lters with a plastic housing are equipped with an interface for fi tting a water level sensor. This sensor is not installed in all vehicles. When the fi lter is new the threaded mounting hole h...

...Range Rover Sport V8 – 4.2L(2006-2008) and LR3(2005-2008) Noise (creaking/squeaking) in the area of the dashboard If there are noises in the Range Rover Sport (see above for model series), such as creaking and squeaking, in the area of the dashboard, the precise cause is diffic...

...BMW E60 Headlamp fogging Water enters the headlamp If heavy fogging or, in some cases, increased water ingress is observed inside the headlamp, this may be caused by a crack in the housing of the SML (side marker lamp) (Fig. 1). The SML is partially covered by the CW seal. (Fig...

...Peugeot, Citroën, Ford, Fiat, Mazda, Mini, and Volvo Idler Pulley Failure Failure of idler pulley due to blocking of cover layer – CT 1092 K1 (1.6-l diesel; 9H engines in Peugeot, Citroën, Ford, Fiat, Mazda, Mini, and Volvo) Power Transmission Group Automotive Aftermarket Conti...

...A borescope is a flexible, bendy inspection camera with an integrated screen. Ring Automotive explains the advantages, and just some of the jobs a hand held borescopes can help you with. A borescope is an ideal tool for inspecting areas or parts which are difficult to reach. The flexible c...

...BMW 3 series (E46) All Touring models Model years 2001-2005 Licence/Number plate lights fail If a customer complains about the above error, this is not necessarily caused by the light source. High levels of humidity in the lights corrode the contacts (see Fig. 1). Capillary action...



...[Previous 10 pages] ... 268 | 269 | 270 | 271 | 272 | 273 | 274 | 275 | 276 | 277 ...[Next 10 of 457 pages] ...
footerlogo
popup