menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Autodata - Audi Q3 - Fuel filler nozzle continuously cuts out Question: A customer's Audi Q3 2.0 TDI is in for a routine service and they have complained that the fuel filler nozzle continuously cuts out when re-fuelling the vehicle. We have experienced the fault when re-fuelling and hav...

...Peugeot 307 - Washer Fluid Problem The washer fluid had gone onto the plug, shorting out the connection between the pins. If left for any length of time. the fluid would have caused permanent damage to the ECU. Driving happily along in her 1.4 litre, 2001 Peugeot 307, the owner was sudde...

...With Tim Stock A Renault Scenic with multiple system faults The wiring diagram identified the connector that affected wiring passed through Heavily corroded wiring in the connector was the cause of the multiple faults This 2008 Renault Scenic was initially brought to a garage because t...

...WWW.MAHLE-AFTERMARKET.COM After repair work on the valve train, a valve may occasionally break off during operation under unfavorable conditions. This is generally caused by an assembly error: a valve spring installed at an angle.If the valve spring is assembled canted unnoticed, uneven f...

...Capillary Action - Sucking up fluids where they don't belong Tim has been getting a lot of calls about coolant, rainwater and other fluids travelling to places they don't belong. Here he gives some advice on capillary action and a few case studies that have resulted in faults due to flui...

...Honda Civic - Swivel Removal Problem Sometimes the wrong way is the right way, and the right way is the wrong way. Confused? Yes, so was I. It was a busy day in the workshop and the job was to replace the lower arm on a 2001 Honda Civic. On the Civic, the lower arm does not have a swive...

  • img
  • Type

    Tech Tip

  • Pressure Waveform Analytics with Frank Massey

  • Jun 19

  • Autoinform (109) Contact
  • PDF

...Pressure waveform analytics At Autoinform Live in Cork last April, Frank Massey's presentation was on compression evaluation. Frank recently attended a presentation by Brandon Steckler on pressure waveform analysis, and here reflects on how this can help you in mechanical diagnosis. Let'...

  • img
  • Type

    Tech Tip

  • LuK?Clutch Academy Peugeot Bipper 1.2 D

  • Jun 19

  • LuK (131) Contact
  • PDF

...LuK Clutch Academy Peugeot Bipper 1.2 D This month, REPXPERT’s Alistair Mason replaced the clutch on a Peugeot Bipper 1.2D. The Bipper is a popular small van with many companies, including motor factors. On this occasion, Alistair completed the job using a scissor lift, but a two...

...Autodata - Citroen DS4 - Engine cranks but won't start Question: We have a 2011 Citroen DS4 2.0 HDi in the workshop that has a non start issue. The vehicle was running when it arrived to us, but was cutting out, and now it cranks but will not start. There are several trouble codes in the...

...Fiat Punto Evo - Coolant leak from intake manifold area Location of leak caused by fuel contamination Question: A 2009 Fiat Punto Evo is in for a routine service and we have discovered an engine coolant leak from around the intake manifold area. We have carried out a pressure check o...



...[Previous 10 pages] ... 303 | 304 | 305 | 306 | 307 | 308 | 309 | 310 | 311 | 312 ...[Next 10 of 452 pages] ...
footerlogo
popup