4511 results

• 
• Type

  Technical Bulletin

• Previous Valeo Technical Bulletins

• Oct 17

• Valeo (135)
• 

...CL 037 Signs worn DMF causes clutch failure Vehicles: All Models with DMF Setup When a Dual Mass Flywheel (DMF) starts to fail, there are tell tale signs on the clutch kit fitted that will help to indicate this. - Markings on the pressure plate (Top Right) On the clutch pressure pla...

• 
• Type

  Technical Bulletin

• Prevoius Technical Bulletins from Valeo Technical Newsletter WK45

• Nov 17

• Valeo (135)
• 

...CL 043 Fitment of friction plate in 828118, 837322 & 837394 Vehicles: Citroen C4 Picasso, C5 1.6HDi Peugeot 3008, 5008, 508 1.6HDi Valeo Technical Support receives a number of calls regarding the fitment of the friction plate in clutch kit 828118...

• 
• Type

  Technical Bulletin

• Priming Concentric Slave Cylinders

• Jan 22

• LuK (131) Contact
• 

...How to Prime a Concentric Slave Cylinder Priming Concentric Slave Cylinders Schaeffler LuK Priming Concentric Slave Cylinders Before Installation: Concentric slave cylinders have been common in hydraulic clutch systems for many years. These slave cylinders can be difficult to bleed i...

• 
• Type

  Technical Bulletin

• Problem Caused by Cabin Filter for traction battery compartment

• May 23

• Blue Print (202) Contact
• 

...Cabin Filter for traction battery compartment Problem Blue Print ADBP250046 To fit: Toyota Prius ZVW30 & ZVW35 models Problem The hybrid traction battery cooling fan is inoperative or provides poor cooling output. The high-voltage battery pack is overheating. Fault codes P0A82 or P...

• 
• Type

  Technical Bulletin

• Problem fitting Oil filter with sealing ring

• Jun 23

• Blue Print (202) Contact
• 

...Problem fitting Oil filter with sealing ring Blue Print ADF122102, ADG05527 To fit: various Citroën, DS, Fiat, Ford, Jaguar, Lancia, Land Rover, MINI, Mitsubishi, Opel, Peugeot, Toyota, Vauxhall and Volvo models Problem When trying to replace the oil filter element ther...

• 
• Type

  Technical Bulletin

• Problem with Timing Chain Kit and Camshaft Bracket

• May 20

• febi (170)
• 

...PROTIPS Technical data can be subject to change Ferdinand Bilstein GmbH + Co. KG Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. +49 2333 911-0 | www.bilsteingroup.com EN To fit: Volkswagen, Audi, Seat & Skoda various models febi 45956 102196, 102426, 106512, 106513, 171970, 1720...

• 
• Type

  Technical Bulletin

• Problems after Installing Intake Manifold Servo Motor

• Aug 20

• Pierburg (204)
• 

...INTAKE MANIFOLD SERVO MOTOR:PROBLEMS AFTER INSTALLATION Potential complaints:• Repeated malfunctions following installation of a new servo motor• Fluctuations in speed and jerking• Diagnostic trouble codes P1018, P208, P2011, P3135 DO NOT FORGET TEACHING-IN! Electric servo motors (01...

• 
• Type

  Technical Bulletin

• Problems Caused by Belt Slip

• May 15

• Gates (127) Contact
• 

...Serpentine System – Problems with Belt Slip Accessory belt drive alternator problem from belt slipping worn tensioner worn damper...

• 
• Type

  Installation Instructions

• Problems following a filter change?

• Aug 13

• MAHLE (144)
• 

...If the engine does not start or fuel leaks occur following a filter change, the cause is often to be found in the fi lter being incorrectly fitted. IMPORTANT: THE CORRECT FITTING ORDER OF THE SEAL AND FILTER ELEMENT TO THE HOUSING AND COVER. If fitted the wrong way round, leaks will...

• 
• Type

  Tech Tip

• Problems from poor fuel quality

• Jan 19

• Autoinform (109) Contact
• 

...Problems from poor fuel quality Ahead of the Autoinform Live training event in Cork in April, Frank Massey wants to get you thinking about problems you are facing in your own garage. This month Frank discusses fuel quality, and how it can be the cause of some failures and poor running pro...