menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...If the preload on the release bearing is too low, this will result in reduced comfort and damage to the clutch. This in turn results in whistling or chirping noises when the clutch is depressed, as well as damage to the release bearing and cup spring. Eventually, the clutch will fail. I...

...Technical Messenger After installing a new radiator, leaks or coolant loss may occasionally be detected on the component. The reason is often an installation error.Frequent cause of radiator damageLeaks are one of the most common complaints following the replacement of a radiator. In many...

  • img
  • Type

    Technical Bulletin

  • Water Pump Installation Guide - Avoiding Common Mistakes
  • Apr 22

  • Gates (127) Contact
  • Video

...Gates Car Water Pump Installation Guide - Avoiding Common Mistakes Watch this Car Water Pump Installation guide that will show you how to install a car water pump properly and avoid the most common mistakes that cause failure during water pump replacement or installation. #CarWaterPump #G...

  • img
  • Type

    Tech Tip

  • LuK Clutch Academy - Audi A5 2.0 TFSI Quattro
  • Apr 22

  • LuK (131) Contact
  • PDF

...Tech Tip from May 2022 LuK Clutch Academy Audi A5 2.0 TFSI Quattro In this month's Schaeffler LuK Clutch Academy, REPXPERT Alistair Mason is replacing the clutch in an Audi A5 2.0 TFSI Quattro that has covered just over 44,000 miles, indicating that the vehicle does short trips with a l...

...On some Volvo S40 and V40 models equipped with a 1.6/1.8/1.9/2.0 litre engines, the wiring in the fuel tank on the fuel level sending circuit can become detached and causes a fuel level fault. PIERBURG provides an overview of the Volvo fuel tank ventilation system and describes how this f...

...VW Golf - Clutch release bearing failure The introduction of the automatic adjustment of the clutch, is something which has probably saved quite a few clutches from premature failure over the years. No longer does the cable need to be slackened off slightly during servicing, to allow for...

...FIAT Fiorino - Low power problem One of my regulars purchased a van for work, and was pleased with the condition of the 2012 Fiat Fiorino, which had covered just over 90,000 miles. The engine was nice and quiet, and did not have the timing chain rattle problems which are often associated...

...The owner of this 2000 Peugeot 306 1.6 Automatic had been in the garage only a few weeks earlier for a puncture repair. At that time, I warned her that the front brake pads were getting very low and they would need replacing in the next few days. The Peugeot was used daily, and the owner...

...The scope trace showed there was a timing misalignment problem Damage on the crankshaft sprocket caused the timing misalignment The customer complaint was that the Transporter, equipped with a CXGA engine, would start well from cold, and ran well with no apparent issues. But if the e...

...Nissan Navara 2.3 dCi with sensor confusion Frequently at the Technical Helpline, more questions are arising regarding AdBlue system errors. The most common, concerns the mileage countdown displayed on the instrument cluster that warns the driver to seek help as the impending non-start...



...[Previous 10 pages] ... 28 | 29 | 30 | 31 | 32 | 33 | 34 | 35 | 36 | 37 ...[Next 10 of 452 pages] ...