4511 results

• 
• Type

  Technical Bulletin

• Autodata - VW Polo: Rear window drops abruptly when opening

• Sep 18

• Autodata (54)
• 

...VW Polo: Rear window drops abruptly when opening Question: A customer of ours with a 2010 Volkswagen Polo 5 door hatchback is complaining that the rear door window glass drops abruptly when opening. We removed the rear door trim and found the window glass detached from the window winder m...

• 
• Type

  Technical Bulletin

• Autodata - Skoda Citigo: Engine coolant blower motor runs continuously

• Sep 18

• Autodata (54)
• 

...Skoda Citigo: Engine coolant blower motor runs continuously Question: We are experiencing a problem on a 2012 Skoda Citigo, where the engine coolant blower motor runs continuously after switching the ignition off. We have carried out some basic wiring checks, but we haven't found the caus...

• 
• Type

  Technical Bulletin

• Concentric Slave Cylinder (CSC) Bleeding Process

• May 18

• LuK (131) Contact
• 

...Bleeding process of CSC 510 0097 10 Modified hydraulic connectionManufacturer: Dacia Nissan RenaultFor current listing refer to parts catalogueThe hydraulic connection of concentric slave cylinder 510 0097 10 has been modified. It now corresponds to the configuration used in current veh...

• 
• Type

  Technical Bulletin

• Water Pump with Electro-Magnetic Clutch

• Apr 16

• FAI (38)
• 

...faiauto.com Factory guide and introduction.WP6558- This water pump has two pulleys: Master Pulley and Slave Pulley.- The Master Pulley is fixed on the shaft by screws and when the Master Pulley rotates, the impeller rotates in turn.- Between Master Pulley and Slave Pulley, there is an 'Int...

• 
• Type

  Technical Bulletin

• Diagnosis of worn wheel end bearings

• May 17

• FAI (38)
• 

...Wheel end bearings SuspensionAxial rods Steering Rack Gaiter KitsStabilizer Link BarsRubber-to-Metal Track control arms General informationWheel end bearingsDrag Links and Centre ArmsTie rod ends V-Torque rodsBall jointRepair kitsTie rod assemblies Expert tipsSteeringWishboneLight Vehicle...

• 
• Type

  Technical Bulletin

• Head Surface Finish

• Apr 18

• FAI (38)
• 

...faiauto.com Before fitting a replacement head gasket Head Surface Finish Ensure the cylinder head and engine block surfaces have been checked, ensuring level sealing surfaces.Maximum values: Roughness...

• 
• Type

  Technical Bulletin

• Bolt Tightening Sequence - Crankshaft Seal

• May 18

• FAI (38)
• 

...faiauto.comOS1002R Bolt Tightening Sequence Best Availability. Best Value. Best Quality. Best Service. Technical Bulletin May 2018+44 (0) 1525 351800 TB0012...

• 
• Type

  Technical Bulletin

• Damper Pulley Bolt Torque Settings - Ford 2.2 & 2.4 Duratorq

• May 18

• FAI (38)
• 

...faiauto.comFord 2.2 & 2.4 Duratorq Bolt Torque Settings CAUTION: Damper pulley retaining bolts MUST only be used 3 times Best Practice:After installation, stamp the damper pulley bolt head with a centre punch to indicate usage. The bolts should be tightened in 2 stages Stage 1: 30 Nm Stage...

• 
• Type

  Technical Bulletin

• Automatic Belt Tensioner Variants on Ford Petrol Engines

• May 18

• FAI (38)
• 

...faiauto.comT9315: One Tensioner, two designs.Automatic Belt TensionerContitech V55226INA 531058610QH QTT948Febi 11291Gates T43127SKF VKM14222NTN GT352.18T9315 has been in FAI's offer for many years as it is used in TBK104 and fits a large range of Ford petrol engines. The tensioner which...

• 
• Type

  Technical Bulletin

• Timing Belt - Ford 1.8 TD Lynx Engine

• May 18

• FAI (38)
• 

...faiauto.com Engine Timing Retrofit - DON'T DO IT!!!Ford 1.8 TD Lynx Engine The Ford 1.8 Lynx engine was originally designed with a timing belt drive for the camshaft and chain drive for the injection pump. In 2007 OE re-engineered the engine to use a wet belt in place of the injection pump...