menu

Search 4,584 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3957 results

...Due to a change of design of the anti roll bar mounting by the car manufacturer, problems occurred when fitting the stabilizer mounting (febi 27355). The former semi-circular design has now been changed to a flat design identical to the original part (see picture 3).This means the mountin...

...Technical Info www.contitech.de Problem: Problem: The tension setting as the cutoff voltage (T2) for the BTT Hz is specified as 150 - 160 HZ in the manual. Subjective measurement results in the timing belt being tensioned too high. The tension setting as the cutoff voltage (T2) f...

...Technical Info www.contitech.de Defect pattern: Defect pattern: The tensioner pulley collapses after a short running time and possibly has a separate barrel jacket from the bearing core. The barrel jacket has mostly strong traces of rubbing. The back of the timing belt is often considerab...

...Rear axle mounting – Fitted in only – Quick and easy febi no. 12244 Fits Fiat Punto (1993-1999) Lancia Y · Fiat Barchetta You know the problem, don't you?! The vulcanized front rubber mountings of the rear subframe fail after a certain mileage and cannot be re...

  • img
  • Type

    Technical Bulletin

  • Chrysler-Jeep-Dodge Sump Plug Replacement

  • Jul 08

  • Blue Print (208) Contact
  • PDF

...INF111 Chrysler-Jeep-Dodge Sump Plug Replacement ADA100101 Sump Plug Technical Bulletin ADA100101 is a composite sump plug. The main body and thread of the plug consists of a softer material than that of the sump pan. It is produced this way to avoid damage to the thread on the pan itsel...

  • img
  • Type

    Part Info Sheet

  • Nissan Pick-Up D21,D22 Outer Track Rod End Replacement

  • Jul 08

  • Blue Print (208) Contact
  • PDF

...INF108 Nissan Pick-Up D21,D22 Outer Track Rod End Replacement Outer Track Rod Ends ADN18715 & ADN187104 Please be aware that part numbers ADN18715 & ADN187104 shown below, although similar in appearance, are NOT interchangeable and should NEVER be substituted for each other. Fitting the...

  • img
  • Type

    Technical Bulletin

  • Ford 1.2, 1.4 and 1.6 engine tensioner

  • May 08

  • Gates (127) Contact
  • PDF

...Technical Bulletin 004 Copyright © 2005 Gates Corporation Page 1 of 1 # 004 27/06/2005 GATES REFERENCE : MAKE : MODEL : MOTOR : MOTOR CODE : K025433XS FORD / MAZDA Fiesta, Focus, Fusion, Puma, 121 1.2, 1.4, 1.6 ZH12FUJA, ZH12FUJB ; ZH14ASDA, ZH14FXDB, ZH14FXDC, ZH14FXDD...

...Technical Information Exchanging the rain/light sensor using a silicone repair set General information Increasingly, rain/light sensors are fitted to the windscreens of modern cars. If it is necessary to replace the windscreen, the question of how to deal with these sensors there...

...Citroen Saxo All models from 1996 to 2003 Interior fan without function If there are complaints about the above-mentioned fault, the contact plate from the ignition-starter switch could be the cause. Individual contacts could be damaged there. In addition, there can be complaints...

...VW Sharan All models from 1995 to 2000 Interior fan runs irregularly If there are complaints about the above-mentioned fault, the fan controller (made up of several resistors) could be the cause. The customer complains that the interior blower only works when switched to the highe...



...[Previous 10 pages] ... 335 | 336 | 337 | 338 | 339 | 340 | 341 | 342 | 343 | 344 ...[Next 10 of 396 pages] ...
footerlogo
popup