4563 results

• 
• Type

  Technical Bulletin

• Multiple systems faults

• Aug 22

• Autobiz (365)
• 

...One wheel speed sensor causing multiple systems faults Vehicle network diagrams were used to identify modules on a common circuit The connector may be grey or black depending vehicle configuration As more and more systems share data from various sensors, vehicle manufacturers have...

• 
• Type

  Technical Bulletin

• Sensor Plausibility, A missed diagnosis

• Aug 22

• Autobiz (365)
• 

...Sensor Plausibility – A missed diagnosis It is critical to determine what is the boost pressure data before the engine is even started When a technician starts the diagnosis process, one of the most common of mistakes the Helpline sees is when a plausibility check of all sensors is...

• 
• Type

  Technical Bulletin

• VAG Water Pump Failure Causing Overheating

• Aug 22

• febi (172)
• 

...ProTip Water Pump To fit various Audi, SEAT, Škoda and Volkswagen models with 1.6 & 2.0 TDi engines Problem The engine is overheating, the coolant temperature gauge reads over 110° C and the interior heater is performing poorly. Additionally, cooling system fault codes may be logged...

• 
• Type

  Technical Bulletin

• VAG Water Pump Connector

• Aug 22

• Blue Print (205) Contact
• 

...To Fit: Audi, Seat, Škoda, Volkswagen. Various models. 1.6 and 2.0 TDi engines...

• 
• Type

  Technical Bulletin

• Sheared timing belt teeth at or shortly after replacement

• Aug 22

• Contitech (165)
• 

...Continental Contitech Technical info 70 ContiTech Antriebssysteme GmbH Techn. Hotline +49 (0)511 938 -5178 www.continental-engineparts.com Philipsbornstraße 1, D-30165 Hannover E-Mail: aam@continental.com The content of this publication is non-binding and is...

• 
• Type

  Technical Bulletin

• Slave Cylinder without a Bleeder Valve

• Aug 22

• REPXPERT (35)
• 

...LuK #LSC309 Slave Cylinder: No Bleeder Valve In the absence of a bleeder valve, Roger demonstrates a reverse bleed procedure. Reverse Bleeding...

• 
• Type

  Technical Bulletin

• Reverse Bleeding of a Slave Cylinder

• Aug 22

• REPXPERT (35)
• 

...LuK Hydraulics: Reverse Bleeding A common culprit of a no-release condition is air trapped in the release system. Pre-bled systems may also contain small pockets of air that can cause headaches. Reverse-bleeding is a simple process that can remedy this problem. clutch slave cylinder &...

• 
• Type

  Technical Bulletin

• Why an oil change is so important for an automatic transmission

• Jul 22

• MEYLE (50)
• 

...The transmission oil in automatic transmissions ages over time and the additives become depleted. Various types of wear debris also build up, particularly in the case of automatic transmissions with wet clutches, where the friction lining sits in the transmission oil. This results in depos...

• 
• Type

  Technical Bulletin

• Cable for camshaft sensor - Mercedes-Benz

• Jul 22

• febi (172)
• 

...Cable for camshaft sensor - Mercedes-Benz febi 107574 PROTIPS Cable for camshaft sensor various Mercedes-Benz models Problem The engine management warning lamp is illuminated, with various fault code entries - referring to the oxygen sensors - logged in the engine control unit....

• 
• Type

  Technical Bulletin

• Propshaft Flexible Disc Installation

• Jul 22

• Bilstein (15)
• 

...Depending on the flexible disc design, there are various indicators to show the correct installation direction of the new part. Four different examples are shown above. The projection of the metal bush must always enter the flange recesses (Fig.1). The arrows on the circumference must...