menu

Search 4,561 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4561 results

...Technical Information Alternator corrosion damage Damage Corrosion damage on alternators can be recognized v ia heavy corrosion on the contacts and on the connection terminals. Causes As a rule, alternators are splash proof as standard. If extreme water entry occurs duri...

...Technical Information Starter overrun Damage Overrun starters can be recognized via tarnishing o n the one-way clutch/pinion, traces of scuffing on the armature shaft, an ejected commutator/armature winding and/or burning of the coil of the solenoid switch. Causes The ca...

...Technical Information LED daytime running lights Design and function Three Luxeon LEDs are used as the light source. These LEDs have a service life of more than 10,000 hours and are therefore particularly suited to continuous operation. In comparison with these, a 12V H7 headligh...

...Technical Information Troubleshooting Hella Dyna Beam bend lighting Troubleshooting In the case of Dyna Beam bend lighting headlight se ts (Golf V, Astra H, Ford Focus I), a control lamp is used which indicates possible malfunction of the system to the driver. After switchi...

...Opel Vectra-C Model year from 2003 to 2005 All vehicles with adaptive running light Control lamp for lighting illuminates. If there are complaints about the above-mentioned fault, the cause could be a faulty power module. In addition, fault codes B1461 and B1462 may be stored. Thi...

...Citroen Saxo With 1.4-litre engine (KFX) Engine misfires when cold/during the warming-up phase. If there are complains with these vehicles that the engine misfires when cold or when in the warming-up phase, one possible cause is a software fault in the engine control unit. In most...

...Mercedes Benz Vito (638) All models with ABS/ASR Control lamp for ASR illuminates, stoplights do not work. If there are complaints with these vehicles that the control lamp for the ASR system illuminates and that the stoplights have failed, one possible cause is a blown fuse. Th e f...

...Mercedes Benz E-Class (W 210) All models with ABS/BAS ABS/BAS control lamp illuminates. If there are complaints with these vehicles that after disconnecting and reconnecting the vehicle battery the ABS/BAS control lamp illuminates and does not switch off, one possible cause is the di...

...Opel Vectra C, Signum Model year 2003 to 2005 Engine code Y30D Engine goes into limp-home mode If there are complaints about the above-mentioned fault, the cause could be a blocked ventilation hole. In addition, fault code P0105 (intake pressure sensor/atmospheric pres sure senso...

...Opel Vectra C Model year 2002 All engines ESP control lamp illuminates If there are complaints about the above-mentioned fault, the cause could be a defective steering-column module. Furthermore, failure of the steering-angle sensor occurs. Due to this, the control lamp for the e...



...[Previous 10 pages] ... 344 | 345 | 346 | 347 | 348 | 349 | 350 | 351 | 352 | 353 ...[Next 10 of 457 pages] ...
footerlogo
popup