menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...CL 043 Fitment of friction plate in 828118, 837322 & 837394 Vehicles: Citroen C4 Picasso, C5 1.6HDi Peugeot 3008, 5008, 508 1.6HDi Valeo Technical Support receives a number of calls regarding the fitment of the friction plate in clutch kit 828118...

...Some Brake Pads are fi tted with wire clamps on the back plate. The inner (piston side) pads are fi tted with wire clamps. These must be correctly seated into the external groove cut into the piston. This device ensures that the pad remains in contact with the piston at all times and is...

...Correct fi tment of inner and outer pads when fi tted with different size or type of backplate spring. Brake Pads with inner and outer pads are often fi tted with a diff erent size or type of backplate spring. The inner and outer pads are not interchangeable. Care must be taken to ide...

...Ensure the axle is completely clean and slide the disc carefully on to the axle, taking care not to force the bearing inner ring out of alignment If the bearing inner ring has moved outwards, it must be re-aligned with the outer ring before fi tting the retaining nut. Rotate the disc by...

...Electric fuel pumps E1F, E2T and E3T Blocked pre filter SI 1761 Most modern fuel pumps are flushed through with fuel, which lubricates and cools them. If this does not happen to a sufficient extent, e.g. through soiling, there is a risk of "dry running". Fuel pumps in the E1F, E...

...Oil consumption caused by:Distortion of cylinder bores Distor tion of cylinder bores is easy to identif y from individual, bright areas on the cylinder sliding sur face. As a result, piston rings are not able to reliably seal distor ted or deformed cylinder bores to prevent the ingress of...

...1Feeler gauge0.12PreparationInspectionFirst, clean the pistons thoroughly and remove all traces of oil carbon from the ring grooves. Remove the carbon from the oil return bores using a twist drill and tap wrench; clean the grooves without damaging the groove sides. Replace cracked, collaps...

...Completion of new cylinder heads (OHV engines)Checking the componentsPreparationDe-wax and wash new cylinder heads and check for external damage. Clean oil bores and valve guides with a brush. Note:Carefully clean the mounting par ts to be re-used and replace any defective used par ts.Chec...

...Repair shaft sliding surfaces quickly and simplyShaf t protection sleeves offer a cost-effective alternative to replacement or time-consuming remachining of the broken-in or worn shaf ts. The shaf t protection sleeve is slid easily over the worn sliding surface of the shaf t. This is of te...

...Information on the product range can be found in our catalogue "Engine Bearings".Or ask your local Motorservice partner. We have also provided a lot more information for you at www.ms-motorservice.com and on our Technipedia at www.technipedia.info.Engine bearingsHandling and funct...



...[Previous 10 pages] ... 351 | 352 | 353 | 354 | 355 | 356 | 357 | 358 | 359 | 360 ...[Next 10 of 452 pages] ...
footerlogo
popup