4511 results

• 
• Type

  Technical Bulletin

• Water pump replacement: the do's and dont's

• Dec 18

• Gates (127) Contact
• 

...HOME (/EN)WATER PUMP REPLACEMENT: THE DO'S AND DON'TS08/06/2017Replacing a water pump requires a fair amount of technical expertise. Are you planning on installing a new water pump? These do's and dont's will help you avoid 9 common mistakes.1. DON'T WORRY IF THE NEW WATER PUMP LOOKS A LIT...

• 
• Type

  Technical Bulletin

• How to prevent water pump failure

• Dec 18

• Gates (127) Contact
• 

...HOME (/EN)HOW TO PREVENT WATER PUMP FAILURE15/04/2016The majority of water pump failures are caused by some other factor than a bad-quality water pump. It's easy to blame the pump. But, it takes a good technician to identify the root cause and correct the situation before another water pum...

• 
• Type

  Technical Bulletin

• Typical Coolant Hose Failures

• Jan 19

• Gates (127) Contact
• 

...Typical Coolant Hose Failures Typical Radiator Hose Failures When engines used to be less complicated, your workshop had to carry only a few sizes and types of coolant hoses. But with today's smaller engine compartments, coolant hoses come in all shapes and sizes to fit tight engin...

• 
• Type

  Installation Instructions

• Timing Belt Installation - Audi A4 1.8l 110kw

• Jan 19

• Contitech (157)
• 

...Watch and Work Timing Belt Installation - Audi A4 1.8l 110kw Whether you are replacing a timing belt or timing chain, the “Watch and Work” video series provides practical tips on how to replace drive components correctly. Videos are easy to understand, can be replayed at any t...

• 
• Type

  Technical Bulletin

• Pico Practical: Cylinder identification and relative compression on CRD engines

• Jan 19

• PicoScope (102)
• 

...Pico Practical: Cylinder identification and relative compression on CRD engines Picoscope basics Picoscope overview oscilloscope basics oscilloscope overview This is a recording of the live stream from our first GoToMeeting webinar that took place on 16-1-2018. These webinars are desi...

• 
• Type

  Technical Bulletin

• Ford Mondeo rear suspension replacement

• Jan 19

• febi (170)
• 

...In this video we look at a common suspension wear item on the rear suspension of a Ford Mondeo. With a focus on the importance of replacing any safety critical bolts and fixings during this repair, using a febi Prokit....

• 
• Type

  Tech Tip

• LuK Clutch Academy Freelander 2 TD4

• Jan 19

• LuK (131) Contact
• 

...LuK Clutch Academy Freelander 2 TD4 REPXPERT's Alistair Mason replaced the clutch on a 2008 Land Rover Freelander 2 TD4, fitted with a 2.2 TDI engine. This clutch replacement job can be completed in 5 hours. With the vehicle positioned on the vehicle lift, open the bonnet, remove the b...

• 
• Type

  Tech Tip

• Problems from poor fuel quality

• Jan 19

• Autoinform (109) Contact
• 

...Problems from poor fuel quality Ahead of the Autoinform Live training event in Cork in April, Frank Massey wants to get you thinking about problems you are facing in your own garage. This month Frank discusses fuel quality, and how it can be the cause of some failures and poor running pro...

• 
• Type

  Tech Tip

• When to replace a Receiver Dryer

• Jan 19

• Nissens (25)
• 

...When to replace a Receiver Dryer The receiver dryer is a filtering unit, located on the high-pressure side of the AC loop, between the condenser and the expansion valve. The receiver dryer's main role is to filter particles and debris in the AC circuit, as well as to absorb any moisture i...

• 
• Type

  Technical Bulletin

• Autodata - Opel Astra: Clicking noise from right A pillar when driving

• Jan 19

• Autodata (54)
• 

...Opel Astra: Clicking noise from right A pillar when driving Question: A customer of ours is complaining that their 2010 Astra is making a clicking noise from the RH A pillar area when driving. We have heard the clicking noise on a road test, but we have been unable to find the source of t...