menu

Search 4,647 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4616 results

...Opel Astra G, Zafira, Vectra B All models from model year 1998 Airbag warning light illuminates If there are complaints about the above fault, poor contacting in the restraint system (seat belt tensioner) connector could be the cause. In this case, the cable ends must be connected wit...

...Ford Galaxy with automatic air conditioning Model year up to 01.02.1996 Poor heating performance If there are complaints about the above-mentioned fault, a flap in the heating housing not closing completely could be the cause. To eliminate this fault, the stop on the servomotor for the...

...Mercedes Benz C-Class (W 202) Model year from 01.06.1996 to 30.06.1997, with engine 111 Air conditioning condenser fan runs constantly If there are complaints about the above-mentioned complaint, incorrect connector sealing could be the cause. This can lead to water penetrating the cond...

...VW Golf 3 Bulb replacement / number plate lighting With vehicles that have as a light source bulbs with a glass bayonet, difficulties often occur during replacement. The bulbs are so tight in the fitting that they cannot be pulled out by hand (providing they can be grasped at all, on...

...BMW Mini (R50) Bulb replacement / rear lamps In order to replace the bulbs in the rear lamps of the above-mentioned vehicles, proceed as follows: • Remove the luggage compartment cover • Remove the side trim panel (Fig. 1, Item A) • Remove the first-aid box (left-hand side only)...

...Chrysler PT-Cruiser Model year 2001-2003 Without turbo engine Service connections With the above-mentioned vehicles, there is some confusion due to the number and arrangement of the service connections. The high-pressure-side connection marked “A” in the drawing i...

...Saab 9-3 Up to chassis no.: X2030478 or X7024091 Hazard warning system is activated independently. If there are complaints with these vehicles that the hazard warning system is activated independently, one possible cause of the fault is the DICE – control unit (DICE = Dashboard Integr...

...Technical Information Automatic headlamp levelling General points Automatic headlamp levelling systems adapt the angle of inclination of the headlamp to the position of the vehicle on the road without the driver having to intervene. Such systems are required by law for xenon headla...

...Technical Information Headlamp Conversion Conversion from asymmetrical to symmetrical illumination of the road. If drivers want to drive in a country where the traffic flow changes (right-hand traffic ⇔ left-hand traffic) it is necessary to convert the vehicle headlamps accordingl...

...Opel Vectra C All models with xenon headlamps Headlamps adjusted too high If there are complaints about the above-mentioned problem, a faulty control unit (headlamp levelling) could be the cause. After the dipped beam has been switched on, both headlamps usually move through a “refe...



...[Previous 10 pages] ... 409 | 410 | 411 | 412 | 413 | 414 | 415 | 416 | 417 | 418 ...[Next 10 of 462 pages] ...
footerlogo
popup