menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Alternators with heavily oil-fouled vacuum pump Damage In the case of some vehicles with diesel engines, the vacuum required for the brake booster is created by a vacuum pump fitted to the alternator. A frequently-occurring problem is that these alternators are...

...WWW.MAHLE-AFTERMARKET.COMA battery temperature sensor can prevent the vehicle's battery from overheating and becoming damaged. Depending on their application, some alternators are fitted with an additional connection for this sensor. This is the case with MAHLE alternators MG 207 and MG...

...WWW.MAHLE-AFTERMARKET.COMA battery temperature sensor can prevent the vehicle's battery from overheating and becoming damaged. Depending on their application, some alternators are fitted with an additional connection for this sensor. This is the case with MAHLE alternators MG 207 and MG...

...Vehicle platforms having overlaps on year of manufacturer are increasingly common. This leads to changes and variations of the models and choices of parts fitted to the vehicle. A common misconception is that ‘they look the same so it will be fine’, but this is not always the cas...

...Alternator/Starter Failure Caused by Fuel and Water Ingress The number of failures caused due to fluid contamination is rising. Many applications now have starter motors and alternators installed under or around some form of lubricant/fluid component or pipes. Fuel filters, power steering...

...Technical MessengerWorkshop InformationIssue no. 08/2016: Shaft separation in alternatorswww.mahle-aftermarket.comFigure 1: Separated threadFigure 2: Impact drivers are only used to loosen the pulley, NEVER to tighten it!Figure 3: Always use a hold-down tool and torque spanner to tighten t...

...This fault is found on Ford Transits with 2.2TDCi engines from 2006 to 2012 (Alternator Part No. AEK2977) A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt contaminating the crankshaft pulley and causin...

...Alternator pulley/bearing failure caused by water contamination on crankshaft pulley Ford Transit 2.2TDCi 2006-2012 Part Number affected: AEK2977 A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt...

  • img
  • Type

    Technical Bulletin

  • Alternator overrunning pulley problem on Mazda

  • Jun 23

  • Blue Print (202) Contact
  • PDF

...Blue Print ProTip ADM561302 Alternator overrun pulley To fit: Mazda CX-30, CX-3, CX5 I & II, Mazda 2 III, Mazda 6 III & IV Engines: 1.5d, 1.8, 2.2d Problem The vehicle becomes difficult to start and displays signs of overheating, and/or there is a ‘squealing’ noise from th...

...THIS BULLETIN ONLY APPLIES IF YOU HAVE THE FOLLOWING 3-PIN STRIP PLUG ON THE ALTERNATOR: A known fault exists which can result in a charging fault. This can be the alternator showing as overcharging and/or charging with the warning light on. This alternator is operated through a sma...



...[Previous 10 pages] ... 426 | 427 | 428 | 429 | 430 | 431 | 432 | 433 | 434 | 435 ...[Next 10 of 452 pages] ...
footerlogo
popup