...Technical Information Accelerator pedal position sensor General On modern vehicles the percentage of electronic components is increasing. Reasons for this, are among others, the legal regulations, e.g. emissions and fuel consumption reduction, the increase of active and passive safet...
...Saab 9-5 Up to chassis number W3051800 Number plate light does not illuminate. If the number plate light on this vehicle does not illuminate, a possible cause could be the deformation of the lamp bracket. Due to the neat the lamp brackets are deformed and the lamps go out. To solve the...
...Saab 9-5 With air-conditioning Noises from the condensed water drain. If a gurgling noise can be heard in the inside of the vehicle, a possible cause could be the air-conditioning water drains. The drains are located under the vehicle, on the right and left side body sill near the front...
...Toyota Carina E and Avensis Water Pumps ADT39145 (Aisin) & ADT39177 (SEM) - 7AFE 1.8 engine ADT39143 (Aisin) & ADT39159 (SEM) - 4AFE 1.6 engine Blue Print catalogue a choice of water pump after specific manufacturing dates on the Carina E (AT190 & AT191) and the Avensis (AT221) models...
...Hyundai Lantra 1.6/1.8 KF Models Only (With G4CR or G4*N DOHC engines) Caution when fitting ADC47514 Timing Belt We have experienced several claims for ‘timing belt failure’ on the above model. Thorough investigation has identified the cause as insufficient timing belt operat...
...Nissan Micra K10 Series Clutch We have found that the Nissan Micra suffers from common problems causing premature clutch failure. Awareness of these problems prior to fitment will allow the correct preventative action to be taken. Symptoms: Jerky/stiff pedal operation Clutch drag (poor ge...
...INF040 Toyota Supra 3.0i Head Gasket Replacement We have encountered several instances of head gasket failure on the Toyota Supra 3.0 turbo and non turbo models resulting from engine overheating. It is our understanding that, if the engine is allowed to overheat, cylinder head distortion...
...Toyota Celica 2.0 GT Injection (ST182/3S-GE) CV Joints Difficulty is often encountered removing the original CV joint from the driveshaft on the above application. This is because the manufacturer uses a ‘heavy duty’ type internal circlip to retain the joint. It is sometimes n...
...Some models of Toyota Carina E were manufactured with two types of steering rack, listed in the Blue Print catalogue as ‘+ZF’ (for the ZF branded rack) or ‘-ZF’ (for the Japanese sourced rack). Although outwardly the track rod ends are the same size and shape, the Z...
...Isuzu Trooper Water Pump Application ADZ99107 We have been informed of several instances of water pump bearing failure on Isuzu Trooper 3.1DT models where a pump designed for use on the 2.8 model (ADZ99107) has been used. Please note that the current Blue Print catalogue application MUST...