menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Flushing Flushing the air-conditioning system and its components Air-conditioning systems are flushed to remove impurities and damaging substances from the refrigerant cycle. The following information has been drawn up to provide support for users new to the subje...

...Technical Information Air-conditioning system nitrogen set 150 General points The air-conditioning system can become damaged foll owing compressor damage or on account of old dryers. Equally, if the air-conditioning system is open for a longer period, e.g. after an accident, lots of...

...Technical Information Refrigerant analysis devices Impure and/or combustible refrigerants can result in a number of hazards: • Damage or soiling of air conditioning components and service units. • Soiling of refrigerant bottles by so-called "drop ins" for example (refrigerant mi...

...Technical Information Tube connector (Vulkan-Lokring) Again and again, tubes and connections become damaged due to vibration or on account of non-professional routing. Usually these tubes are replaced by new ones. It is not absolutely necessary to fall back on original tubes which ar...

...Technical Information Toothed belt / coolant pump kits General When replacing the toothed belt, all components of the belt drive should be replaced with it. For this purpose, Behr Hella Service offers complete kits (Fig. 1) including coolant pump, toothed belt, as well as any tens...

...Q2 / 2014 Brake calliper with integrated handbrake mechanism Assembly note for replacement brake callipers General installation note Handbrake callipers are usually set or adjusted so that the distance between the brake lining and the brake disc is at least (X) + 1 mm (fig. 1). I...

...Brake disk General information Since the introduction of the disk braking system to the automobile, it has become a key structural component in automotive engineering. Together with the brake lining, the brake disk forms a friction couple which is subject to wear and tear and must be...

...Brake discs with wheel bearing and impulse ring General information As a result of the extreme variety of axle constructions produced by all the different car manufacturers, wheel bearings and impulse rings of the anti-lock braking system (ABS) are also integrated into the brake discs...

...Legal Requirements For Brake Pads/Linings ECE R90 Regulation The ECE regulations include a list of internationally agreed, standardised technical rules for vehicles and spare parts and for the equipment used in vehicles. Brake pads and their linings, as safety-related spare parts, bel...

...Notes for running in the brake discs General information After mounting the new brake discs and pads, the friction surfaces of both components need a certain time to adapt to one-another. In order to guarantee a safe and trouble-free function of the wheel brake, it is necessary to mat...



...[Previous 10 pages] ... 45 | 46 | 47 | 48 | 49 | 50 | 51 | 52 | 53 | 54 ...[Next 10 of 452 pages] ...
footerlogo
popup