menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical Information Injectors General Injectors have the task, during all driving conditions, to inject the correct amount of fuel calculated by the ECU. For good fuel atomisation and small condensation loss an engine specific distance to the inlet valve and injection angle a...

...Technical Information Inlet Air Temperature (IAT) Sensor General IAT sensors sense the air temperature on the inlet side of the engine. The voltage signal, produced by the sensor, is passed to the ECU. The ECU evaluates the signal and influences the fuel injection timing and ignition t...

...Technical Information Knock Sensor General You can find the knock sensor mounted on the side \ of the engine block. It recognises knock or pinging under all engine operating conditions to avoid lack of performance....

...Technical Information Level control switch for engine oil General Oil level control switches are fitted in the oil sump. They records the minimum oil level and send a signal to the ECU when there is an engine oil shortage. The ECU activate the warning system, a warning light or...

...Technical Information Level switch for windshield washer General The windshield washer switch records the low washer fluid level. They prevent a failure through water shortage. Function A magnet fitted in a float sinks when the washer fluid level is dropping and...

...Technical Information Manifold air pressure sensor (MAP) General The manifold air pressure sensor measures the vacuum in the induction pipe after the throttle valve. The readings taken by the MAP sensor and the intake air sensor are used to compute the volume of air intake. The result...

...Technical Information Intake manifold pressure sensor with integrated intake air temperature sensor General The intake manifold pressure sensor measures the intake manifold vacuum that exists in the intake manifold after the throttle. The measured values of the intake manifold pressure sen...

...Technical Information Secondary air injection system (SAI) General To achieve a further reduction of the exhaust emission during the cold start and warm up, some vehicles have an additional secondary air system fitted. This system reduces the CO and HC emissions....

...Technical Information Thermal oil-level sensor General points The thermal oil-level sensor has the task of monitoring the oil level and the oil temperature. It is installed in the oil pan from below. The oil-level sensor components (level sensor, temperature sensor and sensor electroni...

...Throttle Potentiometer General The throttle potentiometer senses the opening angle of the throttle valve. It send the information to the ECU to assist in calculating the correct fuel injection. The throttle potentiometer is fitted at the throttle valve axle. Function...



...[Previous 10 pages] ... 50 | 51 | 52 | 53 | 54 | 55 | 56 | 57 | 58 | 59 ...[Next 10 of 452 pages] ...
footerlogo
popup