menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3584 PDF Files Listed

...Mercedes Benz M-Class (W163) Type 163. ... .A from 145273 Type 163. ... .X from 708319 SRS warning light comes on If there are complaints about the above-mentioned problem, a faulty contact on the side airbag could be the case. Faulty plug locking on the airbag unit (see figure) leads...

...Citroen C3 All models with petrol engine Engine judders and stops. If there are complaints with these vehicles that the engine judders and/or stops, one possible cause is an interruption in the plug connection between the crankshaft speed sensor and the connection cable. Due to poor p...

...Opel Zafira A Model years: 2000 to 2005 Fluctuating fuel gauge If there are complaints for these vehicles that the tank gauge does not display "Full" (4/4), [instead displays approx. 3/4] even though the tank is full, a possible cause could be that the fuel pump assembly is not correct...

...Volkswagen Sharan Model year: 1998–2001 Engine: AFN With Climatronic Air-conditioning system is not functioning No error code recorded If the air conditioning on one of the above vehicles fails, you should first check the fuses and the magnetic clutch. If they are OK you can then c...

...Volvo V70 Model years: 2008 - 2009 Vehicles equipped with air conditioning and electric auxiliary heater Condensation water drain hose Short-circuit of electric auxiliary heater In the above vehicles, a clogged condensation water drain hose may cause a short circuit in the electric...

...Technical Info www.contitech.de Defect pattern: Defect pattern: The belt drive makes noises after operating for a short time, The belt drive makes noises after operating for a short time, Cause of error: Cause of error: The newly installed tension roller is not the correct dis...

...Cylinder chamfers during engine reconditioning work© MS Motor Service International GmbH – 0408 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKolbenschmidt Pierburg grou PS E R V I C EIN f o r Ma t Io NSituation:the piston ring heights in pa...

...VALVESINSTALLATION AND ADJUSTMENT ERRORS Incorrect valve clearance settings Cause: The valve clearance has been set too tight or the maintenance intervals have been exceeded. Consequence: The value no longer closes properly. Combustion gases �ow past the valve seat and heat up t...

  • img

  • Technical Bulletin

  • Hyundai/Kia Oxygen Sensor Problem

  • Jun 22

  • Blue Print (202) Contact
  • PDF

...Problem The engine is running unevenly, fuel consumption has increased and the ‘check engine’ warning lamp is illuminated. Fault code P0141 - O2 sensor heater circuit (bank 1, sensor 2) malfunction is stored in the engine control unit (ECU). The fault re-appears after a new oxyg...

...Ford Mondeo with Xenon light Model year from 2000 Light source replacement To replace the light source in the above-mentioned vehicle, proceed as follows: - Switch off the ignition. - Remove the bayonet locks and pull the front grille off forwards (see Fig. 1). - Pull out the locking...



...[Previous 10 pages] ... 120 | 121 | 122 | 123 | 124 | 125 | 126 | 127 | 128 | 129...[Next 10 of 359 pages] ...
footerlogo
popup