3584 PDF Files Listed

• 

• Technical Bulletin

• Hydraulic Tensioners

• Feb 07

• Gates (127) Contact
• 

...Hydraulic Tensioners FORD / OPEL / VOLKSWAGEN GROUP MULTIPLE Hydraulic Tensioners Introduction Belt drive systems for both timing and accessory drive can have different tensioning systems. In the past, engines used a manual tensioner (or eccentric pulley) for the drives, which had...

• 

• Technical Bulletin

• Hydraulic versus Mechanical Tensioners

• Oct 15

• Gates (127) Contact
• 

...Timing belt drive systems come with a variety of tensioning methods and components. In the past, engines used a manual tensioner (or eccentric pulley) for the drives, which had to be installed and then locked in place. Over time the belt tension would change as there is no self-adjustment...

• 

• Tech Tip

• Hydro-mount bushing

• Sep 13

• SWAG (23)
• 

...A match made in rubber & metal Vehicle chassis are becoming increasingly complex, with more importance being placed on rubber metal components. To improve the steering performance and driving stability, the rubber metal components are used as a flexible joint between the chassis and the b...

• 

• Technical Bulletin

• Hyundai 1.4-1.6-l/16 V Belt Falure

• Jul 12

• Contitech (157)
• 

...Belt failure due to improper installation of the tension spring: CT 942 K1 (Hyundai 1.4-1.6-l/16 V, various models) Belt failure due to improper installation of the tension spring: CT 942 K1 (Hyundai 1.4-1.6-l/16 V, various models) Power Transmission Group Automotive Aftermarket Cont...

• 

• Technical Bulletin

• Hyundai Accent - Engine light on, fault code P0133

• Sep 06

• Hella Ireland (1757)
• 

...Hyundai Accent, Model year: 2000–2002, 1.5-litre and 1.6-litre engine Engine control lamp illuminates If a fault is shown via the control lamp and the fault code “P0133 lambda probe bank 1 sensor 1 reaction time too high” is found when checking the fault memory, a check should be...

• 

• Technical Bulletin

• Hyundai and Kia Oxygen sensor problem

• Jun 22

• Blue Print (202) Contact
• 

...www.blue-print.comwww.blue-print.com EN Ferdinand Bilstein GmbH + Co. KG Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. +49 2333 911-0 | www.bilsteingroup.comTechnical data can be subject to change PROTIPS Problem The engine is running unevenly, fuel consumption has increased and th...

• 

• Technical Bulletin

• Hyundai Atoz 1.0L G4HC - Engine runs roughl

• Jul 07

• Hella Ireland (1757)
• 

...Hyundai Atoz 1.0-litre Engine code G4HC All vehicles until model year 12.99 Engine runs roughly If there are complaints about the above-mentioned fault, the cause could be a defective wiring harness. Further complaints may be: - No engine power - Delayed throttle response - E...

• 

• Technical Bulletin

• Hyundai Getz - Engine misfires and loses power, engine light on

• Nov 14

• Hella Ireland (1757)
• 

...Hyundai Getz Model year: 2003–2005 Engine: 1.1l petrol (G4-HD) The engine misfires and loses power, the engine malfunction indicator light comes on. If a customer complains that the engine for the above-mentioned vehicle is experiencing an ignition failure and losing power, and tha...

• 

• Technical Bulletin

• Hyundai Getz - Engine misfiring and rough idling

• Sep 14

• Hella Ireland (1757)
• 

...Hyundai Getz Model year: 2002 to 2005 All models with 1.1 l engine Engine is misfiring and rough idling. If a customer complains about the above error, this could be caused by a dirty idle actuator. Due to oil carbon deposits on/in the idle actuator, the values of the engine control...

• 

• Technical Bulletin

• Hyundai i10 - Failed Washer Pump

• Feb 22

• Autobiz (337)
• 

...Tales from the Workshop Steve Rothwell Some owners are quite happy to drive around with a couple of problems, others are not. Some drivers will immediately rush to get the smallest problem fixed, others will run around with quite serious though not mechanically dangerous problems. The...