Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers
3584 PDF Files Listed
-
-
Technical Bulletin
- Mitsubishi Galant VI - Engine will not start, poor engine performance
-
Feb 06
- Hella Ireland (1757)
-
...Mitsubishi Galant VI (EA) Engine: 2.0 i (4G63) Engine will not start / poor engine performance If the above-mentioned faults occur or the engine control lamp illuminates, this can be connected to replacement of the timing belt. There is usually a fault entry related to the ignition sys...
-
-
Technical Bulletin
- Mitsubishi Galant VI - Engine overheats, coolant low, poor heating
-
Oct 06
- Hella Ireland (1757)
-
...Mitsubishi Galant VI (EA) Model year: 09.96–05.01 Engine overheated / Coolant level too low / Noises / Heating performance If, in the case of the above-mentioned vehicles, the engine overheats, or the coolant temperature rises too high, this may be related to the hose in the coolant e...
-
-
Technical Bulletin
- Mitsubishi Galant - Noise from the rear wheel bearings
-
Apr 06
- Hella Ireland (1757)
-
...Mitsubishi Galant All models from 1999 – 05.2001 Noise from the rear wheel bearings. If there are complaints with these vehicles that the rear wheel bearings are making a noise, one possible cause is water penetration. A leak between the wheel speed sensors and the stub axle allows wa...
-
-
Technical Bulletin
- Mitsubishi Fuso - Oil cooler hose
-
Feb 16
- Hella Ireland (1757)
-
...Mitsubishi/Fuso Canter TF/TF1 Model year: 2011-09-16 - 2014-12-17 Oil cooler hose On the above vehicles, the oil cooler hoses on the fully automatic direct shift transmission (Duonic transmission) must be checked and, if necessary, replaced. If this is not done, there is a risk of...
-
-
Technical Bulletin
- Mitsubishi FTO-Galant Idle Speed Control Valve-Stepper Motor
-
Feb 07
- Blue Print (202) Contact
-
...INF096 Mitsubishi FTO-Galant Idle Speed Control Valve-Stepper Motor Product Focus –Idle Speed Control Valve (Stepper Motor) ADC47430 Mitsubishi FTO 2.0 & Galant 2.5 V6 models It is our experience that the Idle Speed Control Valve (Stepper Motor) commonly fails on the Imported...
-
-
Technical Bulletin
- Mitsubishi FTO Crankshaft Pulley Replacement
-
May 07
- Blue Print (202) Contact
-
...INF104 Mitsubishi FTO Crankshaft Pulley Replacement ADC46104C Crank Shaft Pulley Subject - Product Information Vehicle – Mitsubishi FTO 2.0 (DE3A) We have been made aware that the Crankshaft pulley fitted on the Import Mitsubishi FTO 2.0 model is prone to partial or full failure du...
-
-
Technical Bulletin
- Mitsubishi Colt and SMART Forfour Parking Brake Tempoarily Seized
-
Feb 21
- Blue Print (202) Contact
-
...Mitsubishi Colt and SMART Forfour Parking Brake Tempoarily Seized Problem After applying the parking brake the rear brake caliper becomes seized in operation, which could take 5-10 minutes to move freely again. This problem can affect either side separately or both sides together....
-
-
Technical Bulletin
- Mitsubishi Clutch Replacment - Mainshaft Flywheel (Spigot) Bearing Failure
-
May 06
- Blue Print (202) Contact
-
...We have encountered several cases of flywheel (spigot) bearing failure on some Mitsubishi models. The flywheel should be carefully checked or replaced when installing a new clutch assembly. The following points should be noted during routine clutch replacements: A seized flywheel bearing m...
-
-
Tech Tip
- Mitsubishi AYC/ACD system
-
Aug 13
- Blue Print (202) Contact
-
...Mitsubishi AYC/ACD system Written by Jim gilmour Blue Print’s Technical Consultant. electronic stability programmes by any other name have been around for over a decade and have contributed greatly to vehicle safety. Much has been written about them, and for the most part, their op...
-
-
Technical Bulletin
- Mitsubishi 4M41 Diesel Engine Timing Chain Kit
-
Aug 23
- febi (170)
-
...febi 102440,107345 Timing chain kit To Fit: Mitsubishi Montero, Pajero and Shogun models fitted with 4M41 diesel engine. Problem A rattling noise coming from the engine timing chain area or a broken timing chain. Cause The timing chain tensioner’s wear is accelerated...
