...48 September 2022 AUTOBIZ Workshop equipment• Vehicle lift (2 post is ideal)• Engine support• Transmission jack• Clutch alignment toolGearbox removalWith the vehicle still sitting on the ground, slacken the front wheel/locking bolts and both the front hub/driveshaft nuts...
...50 October 2022 AUTOBIZWorkshop equipment used,• Vehicle lift (two-post is ideal)• Engine support• Transmission jack• Clutch alignment tool• Internal circlip pliersGearbox removalWith the vehicle placed on the vehicle lift, slacken the front wheel locking bolts and...
...LuK Clutch Academy Kia Ceed 1.4 CRDi REPXPERT Alistair Mason is replacing the clutch assembly on a 2013 Kia Ceed, which has covered more than 106,000 miles, after clutch slip was diagnosed. With a recommended repair time of three-and-a-half hours and all repair instructions available th...
...LuK Clutch Academy Berlingo 1.6 HDi REPXPERT Alistair Mason is replacing the clutch in a 2012 Citroën Berlingo van, that has covered nearly 218,000 miles. The customer had reported that the clutch was ‘slipping’, which a short road test confirmed. With a scheduled book time of six...
...LuK Clutch Academy Iveco Daily pull type REPXPERT Alistair Mason is replacing the clutch in a 2014 Iveco Daily 35C17 that has covered 56,000 miles and had been recovered with no drive. The scheduled time for the repair is 4.20 hours and with no specialist equipment required, this makes a...
...LuK Clutch Academy Ford Transit II REPXPERT Alistair Mason is focusing on best practice clutch replacement to ensure an efficient and quality repair, using a front wheel drive 2012 Ford Transit fitted with a 2.2 TDCi engine as an example. Noticeably, there are more vans on the roads the...
...Mahle Technical Messenger Issue No.: 02/2009 – Technical Information for Air Filter Element LX 791 Unlimited Use of MAHLE Air Filter Element www.mahle-aftermarket.com, page 1 Technical Messenger The air fi lter element from MAHLE has on both sides the same plastic opened end plat...
...Mahle Technical Messenger Issue No.: 03/2009 – Assembling and Disassembling Valves Even the best valves have to be replaced sometime – no matter if this is due to wear and tear or engine damage, e.g. a valve impact, which, in turn, can be caused by a torn toothed V-belt or chain....
...Technical Messenger Issue No.: 4/2009 – Special Sealings at OX-type Filters Which ever MAHLE Original or Knecht fi lter you look at you can fi nd several patented features, some which improve the fi lter performance and others which make the fi tting easier, more eff ective and ec...
...Mahle Technical Messenger Issue No.: 1/2010 – Assembling and Disassembling Valve Guides The valve guides are very important components in the cylinder head. As the name suggests they guide and support the valves, thus contributing to a long engine life. Like the valves, valve guides...