menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3584 PDF Files Listed

  • img
  • Tech Tip

  • Nissan Navara halfshaft replacement
  • Apr 15

  • Blue Print (202) Contact
  • PDF

...Navara halfshaft replacement Noise and excessive play in the rear wheel bearings are a common problem with the 2005 onwards Nissan Navara D40 pick-up. Blue Print provides instructions on how to best handle this job. A complex setting up and alignment is required of all the components...

...Citroen Berlingo Up to model year 30.06.1997 Humidity in the rear lights If there are complaints about the above-mentioned fault, insufficient water drainage or insufficient ventilation could be the cause. In this case, humidity collects in the light and can cause corrosion on the plug...

...Land Rover Freelander With Td4 engine Engine starts poorly or starter does not turn. If there are complaints with these vehicles that the engine starts poorly, or that the starter no longer turns, one possible cause is an oxidized earth connection. The earth connection between the batte...

...BMW E36 / M52 ECE up to 30.08.95 Fault code lambda sensor With longer intervals in deceleration, a fault code can be generated from the lambda sensor. On longer intervals in deceleration (more than 30 Sec.), the lambda sensor is only circulated by compressed air. This has the consequen...

...Opel Vectra C, Signum Model year 2003 to 2005 Engine code Y30D Engine goes into limp-home mode If there are complaints about the above-mentioned fault, the cause could be a blocked ventilation hole. In addition, fault code P0105 (intake pressure sensor/atmospheric pres sure senso...

...Ford Mondeo Model year: up to 11/1995 Engine: 1.8-litre turbo diesel With air conditioner Engine cannot be switched off with the air conditioner switched on If the warmed-up engine of the above-mentioned vehicles cannot be switched off, the vehicle has possibly not been retrofitted with...

...Toyota Prius II Model year: 2003–2007 Loss of coolant With the above-mentioned vehicles there can be a loss of coolant due to a leak in the coolant pump. The vehicle manufacturer has taken heed of the problem already and initiated a service campaign to remedy it. Since there has no...

  • img
  • Technical Bulletin

  • Diagnosing Tensioner Failure
  • Sep 15

  • Gates (127) Contact
  • PDF

...Unbeknownst to many, automatic belt tensioners are actually a wear item, and therefore cannot be classified as a prototypical hard part. Internal components in the tensioner can fail, causing stress on the belt and other accessory components. A tensioner is a relatively inexpensive part to...

...Code: BETBC32Pages: 1 of 1Caliper Identification CA2542R & CA2802RDifference between CA2542R and CA2802R CA2542 has a shorter 48mm handbrake cable guide than CA2802 CA2802 has a longer 60mm handbrake cable guide than CA2542 Distance between centre of handbrake spindle a...

...Piston ringsFunction and designMaintenance faultsDirt in the intake airDir t that reaches the combustion chamber settles in the ring grooves where it causes abrasive wear in the ring grooves and at the piston ring flanks. This results in excessive ring height clearance and consequently to...



...[Previous 10 pages] ... 72 | 73 | 74 | 75 | 76 | 77 | 78 | 79 | 80 | 81...[Next 10 of 359 pages] ...