menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3584 PDF Files Listed

...Fiat Bravo/Brava Model year from 10.1995 to 10.2001 Low beam cannot be switched on anymore If there are complaints about the above-mentioned fault, the cause could be a defective steering-column switch. Due a small lever in the switch having broken off, the low beam cannot be switc...

...Fiat Punto Type 188 with subwoofer radio system Bulb replacement left hand rear lamp unit To replace the bulbs in the lefthand rear lamp unit, the subwoofer unit in the boot, and the complete lamp unit have to be removed. To do this, proceed as follows: • Remove the boot cover â€...

...Fiat Punto II, Type (188) Condensed water in the headlamp If the above mentioned failure is queried, the cause could be bad ventilation inside the headlamp. This can be recognised by, condensation collecting inside the head lamp and runs as water drops down the lens. In this case on b...

...Fiat Stilo 1.6 Bulb replacement In order to replace the bulb in the above-mentioned vehicle, proceed as follows: Passenger side: - Remove the attachment nuts from the water tank (see Fig. 1) - Pull the water tank off the threaded bolt and push it towards the rear (see Fig. 2). - Push...

...Fiat Stilo All models Water penetrating the headlamp. If there are complaints about t he formation of condensation in the headlamps, one possible cause is water penetrating the headlamp. In such cases, the complete headlamp(s) do(es) not have to be replaced. Only the rear cover has t...

...Ford Fiesta 1.4i From model year 11.01 Replacing the light source In order to replace the light sources in the above-mentioned vehicle, proceed as follows: First switch the ignition off. Driver side: Low beam and high beam: - Remove the rubber cap from the headlight housing (see Fig....

...Ford Focus II 1.6i From model year 11.04 Replacing the light source Since the working steps are identical for both sides for this vehicle, they are explained using one side as an example. Low beam, high beam and parklight: - Unscrew the attachment screw (Torx 30) from the headlight...

...Ford Focus C-Max 1.6i Replacing the light source Since the working steps are identical for both sides for this vehicle, they are explained using one side as an example. Low beam, high beam and parklight: - Unscrew the attachment screw (Torx 30) from the headlight (see Fig. 1). - R...

...Ford Focus All models from 1999–2001 Indicator switch does not reset automatically. If there are complaints with these vehicles that the indicator switch does not reset automatically after indicating, one possible cause is a broken-off reset cam on the air bag clock spring. In...

...Ford Focus build year till 12.07.1999 Moisture in the headlamp Misted headlamps due to broken lens. If the headlamp is misting badly, this can be due to a broken lens. The cause of this is pressure on the headlamp, due to the mounting. In this case the faulty headlamp must be replac...



...[Previous 10 pages] ... 89 | 90 | 91 | 92 | 93 | 94 | 95 | 96 | 97 | 98...[Next 10 of 359 pages] ...
footerlogo
popup