menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3584 PDF Files Listed

...Citroen Berlingo Model years 2002-2008 Failure of the low beam If a customer complains about the above problem, this could be caused by a frayed cable harness. Additionally t here may be electrical failures/malfunctions. The cable harness runs from the fuse box in the engine compart...

...Land Rover Defender 90/110/130 model years 1999 – 2004 with engine 2.5L TD5 Insufficient power If this fault is complained about, then an insufficient sealing of the plug (see Fig.) between the engine wire harness and the wire harness for the injection valves may be the reason. Backf...

...BMW E36 All models with petrol engine Failure of the oxygen sensor If there are complaints about these vehicles concerning the fact that the oxygen sensor is not working, a possible cause is a leaky plug connection for the oxygen sensor in the engine compartment. Moisture which penetrat...

...Opel Signum 2.2L Model year 2003 to 2004 With engine code Z22YH Engine control light comes on If there are complaints about the above-mentioned fault, the high-pressure pump or pressure regulator from the fuel injection could be the cause. In addition, the fault P1191 "high-pressure pum...

...Ford Maverick Up to model year 1998 Overheating of the interior / actuation of heating valve If the interior of the above-mentioned vehicles should overheat with the above-mentioned vehicles or the heating system only delivers hot air, this can be connected to a faulty setting of the a...

...Toyota Landcruiser from build year 09/1997 Noises from the a/c unit On the above -mentioned vehicles unusual noises can be produced with a switched on a/c system. In many cases a vibrating expansion valve causes this. Through the refrigerant, the vibration is transmitted to...

  • img
  • Technical Bulletin

  • CVT Belt Installation
  • Oct 15

  • Gates (127) Contact
  • PDF

...To ensure optimal operation of newly installed belts, the CVT sheaves must be cleaned of all old belt residue, glazing, and oils. Cleaning can be accomplished by carefully scuffing belt contaminates off the sheave/belt contact area with a mild abrasive such as 220-400grit sandpaper, Scotch...

...OBD and fuel supplyFinding and remedying faultswww.ms-motorservice.com© MS Motorservice International GmbH – 50 003 979-02 – EN – 08/14 (122016)Pierburg products01 Fuel delivery module (in-tank)02 Fuel fluid-level sensor03 Activated carbon filter shut-off valve04 Activated carbon fi...

...Steve Rothweel Workshop Tales Tales from the workshop Ford Focus - Pungent diesel smell The body of the fuel injector was leaking diesel The smell of diesel is not on the top of my list of favourite scents. When diesel leaks onto a hot engine, and starts to evaporate, the resultin...

  • img
  • Technical Bulletin

  • Hyundai Lantra 1.6, 1.8 KF Model Timing Belt Replacment
  • Jul 02

  • Blue Print (202) Contact
  • PDF

...Hyundai Lantra 1.6/1.8 KF Models Only (With G4CR or G4*N DOHC engines) Caution when fitting ADC47514 Timing Belt We have experienced several claims for ‘timing belt failure’ on the above model. Thorough investigation has identified the cause as insufficient timing belt operat...



...[Previous 10 pages] ... 92 | 93 | 94 | 95 | 96 | 97 | 98 | 99 | 100 | 101...[Next 10 of 359 pages] ...