Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers
3584 PDF Files Listed
-
-
Technical Bulletin
- VW New Beetle - Poor engine starting, engine knocking at idle
-
Feb 14
- Hella Ireland (1757)
-
...VW New Beetle All models Poor engine starting performance, excessive engine knocking at idle, engine runs in emergency mode. If the above problem is raised, it could have several causes. Implausible values may cause the symptoms described. In addition, the following error codes may...
-
-
Technical Bulletin
- Importance of replacing Brake Fitting Kits
-
Feb 14
- Apec Braking (40)
-
...Old worn out-parts causes: • Tension of springs significantly reduced. • The old parts break or are lost. Old worn out-parts increases the risk of: • Brake noise (the brake pads and clip rattle}. • Unequal and disproportionate wear on the brake pads and a risk of damaging t...
-
-
Technical Bulletin
- VW/Audi TDI PD 1.9/2.0 Tensioner Pulley Failure
-
Feb 14
- Contitech (157)
-
...VW/Audi TDI PD 1.9/2.0 Tensioner Pulley Failure Failure of the belt drive as a result of the tension pulley breaking off after breakage of stud bolt CT 1028 K2/K3/K4, CT 1051 K1/K2 (VW/Audi TDI PD 1.9/2.0 L) Technical Info Der Inhalt dieser Druckschrift ist unverbindlich und dient...
-
-
Technical Bulletin
- Ford/Volvo 2.5 Timing Belt Guide
-
Feb 14
- Contitech (157)
-
...Ford/Volvo 2.5 Timing Belt Guide CT 979K3 timing belt kit for Ford/Volvo 2.5 l Various models from 2004 onwards ContiTech Power Transmission Group Philipsbornstrasse 1, D-30165 Hannover Techn. Hotline +49 (0)511 938 -5178 E-mail: frank.wissbroecker@ptg.contitech.de www.contitech.d...
-
-
Technical Bulletin
- VAG 1.0 16V AST / AVZ & 1.4 16V AFH Tensioner
-
Feb 14
- Gates (127) Contact
-
...VAG 1.0 16V AST / AVZ & 1.4 16V AFH Fig. 2 The tensioner pulley has a "ridged" surface (Fig. 1 and 2). This is intentional. These “ridges” are designed to help reduce belt noise generated by surface contact. Fig. 1 When replacing the timing belt, ensure that a new “ridged” tensi...
-
-
Technical Bulletin
- Increasing importance of the oscilloscope
-
Feb 14
- Pierburg (204)
-
...SERVICEINFORMATIONSI 1414© MS Motor Service International GmbH – 02/14 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyThe right of changes and deviating pictures is reserved. For assignment and replacement parts, refer to the current catalogu...
-
-
Technical Bulletin
- Identification of Brake Calipers 152 & 158
-
Feb 14
- Apec Braking (40)
-
...Identification of Calipers LCA / RCA 152 & LCA / RCA 158Further information on this or any other issue can be obtained from the Apec Trade Helpline 01454 285054 Issue date6th February 2014TechnicalBulletin.These Calipers are fi tted on the rear of Fiat Multipla [1999-2011]Fiat Stilo [200...
-
-
Installation Instructions
- Trivial Pursuit - the search for the turbo culprit
-
Feb 14
- MAHLE (144)
-
...The causes of turbocharger damage generally do not lie in the turbocharger itself, but rather in the engine peripherals. If only the turbocharger is replaced and the actual cause of failure is not remedied, then it will inevitably be damaged again. The new turbocharger will automatical...
-
-
Technical Bulletin
- Kia Picanto - Engine warning light on
-
Feb 14
- Hella Ireland (1757)
-
...Kia Picanto All petrol engine cars up from model year 01/2005 Engine warning light comes on. If the customer complains that the engine warning light comes on, the fault code P0030 (heated lambda probe 1, cylinder row 1, heating control circuit malfunction) may be stored. The cause o...
-
-
Technical Bulletin
- Honda CR-V - Failure of dipped headlight
-
Feb 14
- Hella Ireland (1757)
-
...Honda CR-V Model years: 07.11.2001-17.09.2004 Engine: 2.0 i (K20A4) Failure of dipped headlight. The dipped headlight can fail on the vehicle named above. The cause can be a defect in the connection between the light switch and the cable plug. Friction can wear the coating on the...
