...Ford Probe II With 2.5 l 24V or 2.0 l 16V engine Motor stalls and cannot be started again at all or only with great difficulty. If there are complaints with these vehicles that a warm engine stalls and cannot be restarted or only with great difficulty, one possible cause is an interrupt...
...Rover 45 Condenser fan not working In the case of the above-mentioned vehicles, a non-working condenser fan can be the cause of faults and/or poor air conditioning system cooling performance. It is often established that t he radiator fan works in an uncontrolled manner, with cons tant...
...Citroën XM (Y4) Stop light not working/ stop light switch faulty In the case of the above-mentioned vehicles without ABS, a faulty stop light switch can lead to failure of the stop lamps. The stop light switch (photo) is located in a plastic housing mounted on the brake pedal. The upp...
...MCC Smart Starting problems/immobiliser If the above vehicles are not locked when left, the immobiliser is automatically activated after 5 minutes. When entering the vehicle again, it is not possible to start the engine without deactivating the immobiliser. The immobiliser is activate...
...BMW E38 model year: 09/1998 – 10/1999 E39 model year: 10/1998 – 10/1999 Xenon light not working With these vehicles it can occur that one or both xenon headlamps cannot be switched on although the light switch is in the “dipped beam” position and the ignition has been switche...
...BMW E38 & E39 With automatic transmission Engine cannot be started in P or N. If there are complaints with these vehicles that the engine cannot be started with the selector lever in the P or N positions, this could be caused by the following: • Fault in the fault memory of the trans...
...Ford Mondeo 2001 Ford Focus from 12/2000 Re-programming the radio remote control. With these vehicles it is possible to change radio remote control functions. There are two possible functions of the unlocking button on the hand-held transmitter: 1. Pressing the unlocking button once =...
...Ford Cougar Windscreen air vent becomes loose, air flow is diverted. If there are complaints with these vehicles that the lateral ends of the windscreen air vent become loose, one possible cause is a distorted air vent. To eliminate the problem, the air vent must be removed and fitted...
...BMW E39 up to model year: 03/1996 Stop light stays switched on With the above-mentioned vehicles the stop light could stay on for up to 3 minutes after the ignition has been switched off.This is usually caused by the lamp control module (LCM) not recognising the switching-off of termin...
...Opel Corsa C From model year 2001 with engine Z10XE, Z10XEP, Z12XE, Z14XEP Water loss, engine overheated If these vehicles lose water, resulting in overheating of the engine, one possible cause is a worn water hose. The hose affected is the one from the water pump to the radiator expans...