menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...Technical information H15 light bulb Configuration The H15 light bulb is a 12 volt, 2 filament light bulb, made with a filament each for long distance light (1) and a filament for daytime travel light (2). The output is 55 watts for long distance light and 15 watts for daytime drivin...

  • img
  • Type

    Component Description

  • Hand brake shoes overheating or squealing - Land Rover & Range Rover
  • Jun 23

  • Blue Print (202) Contact
  • PDF

...Blue print Protip to fit: Land Rover Discovery 3, 4 and Range Rover Sport modelsProblem Excessive heat build-up in the rear brakes, squeal from the rear brakes while driving, squeal from the rear brake when the electronic parking brake (EPB) is applied and EPB warning lamp illuminated....

...A number of Apec Brake Discs are handed to aid cooling as per the original equipment disc. Follow venting direction not drill hole pattern. Failure to follow this installation rule will lead to poor performance and possible brake judder. DSK2003 / 2004 DSK2308 / 2309 DSK2310 / 2311...

...What you need to know about working on calipers on a car fitted with an electric parking brake Garage Gurus This video illustrates the two main types of electric parking brake systems and how to service them. The guide also runs through what to do should it not be possible to disengage t...

...Handy blanking pipe A short pipe is a handy blanking plug Like many mechanics, I save the old bleed screws from various units. This come in very handy when replacing brake pipes. The male threaded metal blanking plugs that normally come fitted to ABS units and the like, are useful wh...

...Hard Starting and Running Opel Vectra C 2.2 Petrol Hard Starting / Running Opel Vectra C 2.2 Petrol An Opel Vectra C 2.2litre with the high pressure petrol engine (Z22YH) was at a garage with a running fault. The helpline was called to help diagnose the high pressure fuel system. The...

...faiauto.com Before fitting a replacement head gasket Head Surface Finish Ensure the cylinder head and engine block surfaces have been checked, ensuring level sealing surfaces.Maximum values: Roughness...

...Headlamp beam setter 1-2 Technical Information Headlamp beam setter An important safety aspect in traffic are correctly adjusted headlamps, to provide good exact illumination of the road, with the lowest possible glare to the oncoming traffic. To adjust the headlamps...

...Technical Information Headlamp Conversion Conversion from asymmetrical to symmetrical illumination of the road. If drivers want to drive in a country where the traffic flow changes (right-hand traffic ⇔ left-hand traffic) it is necessary to convert the vehicle headlamps accordingl...

...Technical Information Headlamp power wash systems General information: According to legislation, a headlamp power wash system is compulsory in the case of vehicles with Xenon light. In the case of halogen light as well, these systems make sense for the following reason. The influenc...



...[Previous 10 pages] ... 174 | 175 | 176 | 177 | 178 | 179 | 180 | 181 | 182 | 183 ...[Next 10 of 452 pages] ...