menu

Search 4,514 docs, articles & videos from the world’s leading Automotive part manufacturers

  

4511 results

...  ​Recently, we have noticed a large number of garages calling the Helpline with faults logged for catalyst efficiency below threshold, only to be told the garage has recently replaced the CAT following a failure of the original part. The customer then returns a few weeks lat...

...Issue date11th March 2014TechnicalBulletin.Further information on this or any other issue can be obtained from the Apec Trade Helpline 01454 285054 On some Honda and Rover models between 1996 and 2005, the Brake Calipers LCA / RCA150 can be fitted either Left hand or Right hand depending o...

  • img
  • Type

    Technical Bulletin

  • Honda 1.7L Timing Belt Installation
  • Oct 15

  • Gates (127) Contact
  • PDF

...See installation instructions provided in this kit. Crankshaft must be rotated two turns COUNTERCLOCKWISE with locking pin in tensioner and attachment bolt loose.BULLETIN PA007-11› PART NUMBER: TCK312 TCKWP312 T312› MAKE: Honda› MODEL: Civic› YEAR: 2001-2005› ENGINE: 1.7LINST...

  • img
  • Type

    Technical Bulletin

  • Honda Accesory Belt Drive System
  • Oct 15

  • Gates (127) Contact
  • PDF

...AUTOMOTIVE PASSENGER CAR ACCESSORY BELT DRIVE SYSTEM Technical Service Bulletin ACCESSORY BELT DRIVE SYSTEM HONDA BULLETIN PA010-12› PART NUMBER: 38332› MAKE: Honda› MODEL: Accord Odyssey Pilot Ridge line› YEAR: 2003-2007› ENGINE: 3.0L 3.5LWith over 100 years of experience,...

...Honda Accord Coupe Model year from 1999 until 2000 All models Immobilizer control lamp flashes. If there are complaints about the above-mentioned fault, the cause could be a defective receiving coil on the ignition lock. In addition, there may also be complaints that although the st...

...Honda Accord From model year 2001 All models with variable camshaft control (VTEC) Engine control lamp illuminates, fault code stored. If there are complaints with these vehicles that the engine control lamp illuminates, and fault code P1259 (VTEC-system malfunction) is stored in the f...

...Honda Accord 2.2 CTDI Model year from 2003 With xenon light Replacing the light source When replacing the light source, proceed as follows. First switch the ignition off. Driver side: Low beam: - Unscrew the screw from the earth strap (above the headlight) and place it to one side. - U...

  • img
  • Type

    Technical Bulletin

  • Honda Accord 90-98 Upper Ball Joint Replacement
  • Aug 07

  • Blue Print (202) Contact
  • PDF

...INF106 Honda Accord 90-98 Upper Ball Joint Replacement ADH28668 Upper Ball Joint Subject – Application Guide Vehicle - Honda Accord 1990 > 1998 We have encountered several cases where the Upper Ball Joint part number ADH28668 will not fit some Honda Accord suspension arm applica...

  • img
  • Type

    Technical Bulletin

  • Honda Accord 98-03 Clutch Master Cylinder Replacement
  • Apr 07

  • Blue Print (202) Contact
  • PDF

...INF102 Honda Accord 98-03 Clutch Master Cylinder Replacement Clutch Master Cylinder ADH23414 Application Guide Honda Accord 7/98 > 3/03 We have been made aware that Honda has suffered a supply problem on the Clutch Master Cylinder fitted to some early UK specification Honda Accord mod...

...Certain Honda vehicles have a known fault in the drive belt system that results in the premature failure of the alternator pulley and/or bearings.These are: Accord 2.2 CDTi 2004-2008 FR-V 2.2 CDTi 2005-2010 with Honda Engine Codes: i-CDTI N22A1 2004-2011 Some of the vehicles are ori...



...[Previous 10 pages] ... 176 | 177 | 178 | 179 | 180 | 181 | 182 | 183 | 184 | 185 ...[Next 10 of 452 pages] ...