...CVJ –ENG/02 –05/2019CV BOOT KITSRecommended clamp tightening proceduresCaution. If the clamp is not tight enough :(M1. M2 à 4mm)➢Greaseleakage. If the clip is too tight: (M1. M2 à 1.2mm)➢The CV boot can split and allow grease to leakTorque:WithHAZET5110-2CTplierorCLASplier. C...
...BGI-300698 Technical data can be subject to change | FEB20Ferdinand Bilstein GmbH + Co. KG Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. +49 2333 911-0 | www.bilsteingroup.comFor more technical information please visit: partsfinder.bilsteingroup.comDE KraftstofffilterEN Fuel Filte...
...PRO TIPSTechnical data can be subject to change Ferdinand Bilstein GmbH + Co. KG Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. +49 2333 911-0 | www.bilsteingroup.comEN to fit:Nissan Almera, Almera Tino, Expert, Micra, Note, Primera,Sunny, Wingroad 1.0, 1.2, 1.4, 1.5, 1.6, 1.8 Petrol e...
...WHEEL SIDE JOINTDISASSEMBLY / ASSEMBLYCVJ –ENG/04 –01/2020Step by step for dismounting and mounting the wheel side joint❖1ststep : disassembly1Dismounting of tightening components: small and big clampUse a cutting tool or a hacksaw to open the clampsHacksaw2The boot removing can be d...
...Peugeot Bipper - Hard or no start engine Question: We are having difficulty diagnosing a fault on a 2011 Peugeot Bipper 1.3 litre Diesel. The engine is difficult to start, and intermittently does not start at all. We have checked fuel and air supplies, and they are OK. We have also checke...
...Mercedes C-Class - Coolant leak from Intake Manifold Question: We have a 2009 Mercedes-Benz C-Class in the workshop with a coolant leak. We have narrowed the coolant leak down to the intake manifold area but haven't managed to pinpoint the exact cause. We are reluctant to replace the int...
...LuK Clutch Academy Audi A1 1.6TDi This month, REPXPERT Alistair Mason, replaces the clutch on a 2016 Audi A1, fitted with a 1.6 TDi. With a repair time of just five hours and a requirement for only minimal workshop equipment – a two-post lift, engine support, transmission jack, clutch a...
...Citroen/Peugeot rear brake disc installation The gap between the wheel speed sensor and the sensing ring on a brake disc is very important to the correct operation of the ABS or other steering control systems. Borg & Beck detail what is needed in Citroën/Peugeot models to carry out a s...
...Tales from the Workshop Steve Rothwell Peugeot 306 - Charging Problem The battery terminal was the cause of all the problems This 1998 Peugeot 308 diesel had been suffering from sluggish starting for a while. The owner decided that the battery must be the source of the problem an...
...Tales from the Workshop Steve Rothwell BMW M5 - Spark Plug Replacement The rear plug on the nearside bank is the most difficult to replace When I first entered the motor trade, if a set of spark plugs lasted for 12,000 miles without a hiccup they were doing well. Modern spark p...