menu

Search 4,511 docs, articles & videos from the world’s leading Automotive part manufacturers

  

14 results for "sheared timing belt"

  • img
  • Type

    Technical Bulletin

  • Timing belt/kit installation on VAG 1.4 & 1.6 16V

  • Mar 10

  • Gates (127) Contact
  • PDF

...arks Bolt sheared off Not far enough over bolt head Gap Good position No gapTechnical Bulletin 035 Copyright © 20 10 Gates Corporation Page 3 of 6 # 035 25/03/ 2010 Too high torque can resu lt in: - deformation of the tensioner leading to overheating of the bearin...

  • img
  • Type

    Technical Bulletin

  • VAG 2.5 V6 TDI – Timing Belt set-up

  • Mar 11

  • Gates (127) Contact
  • PDF

...g, with a sheared bolt as a result (Fig. 7) Fig. 6 Fig.7Technical Bulletin 042 Copyright © 2011 Gates Corporation Page 3 of 4 # 042 31/01/2011 12) Install rest of tensioner system. ATTENTION!!! Particular attention needs to be taken in relation to the...

...t of true sheared studPOIssued 08.2015 / INA 0512 / Technical content subject to change OE Manufacturer's names and numbers are used for reference purposes only© 2014 Schaeffler Automotive Aftermarket GmbH & Co. KGService InfoYou want more? We can help!Phone: +44 (0) 1432 264 264*Fax: +44...

...e bolt is sheared offCAUSES• Inadequate tightening torque• Fatigue of the bolt caused by the up and down motion of the roller. Bolt subjected to shearNTN-SNR RECOMMENDATIONS• Tighten the bolt to the specified torque• Oil the smooth part (seat) of the retaining bolt. Note oil must...

...e bolt is sheared offCAUSES• Inadequate tightening torque• Fatigue of the bolt caused by the up and down motion of the roller. Bolt subjected to shearNTN-SNR RECOMMENDATIONS• Tighten the bolt to the specified torque• Oil the smooth part (seat) of the retaining bolt. Note oil must...

...n peg had sheared off and the pulley had spun on the camshaft. A new pulley was ordered and fitted, but the belt seemed too long. It is worth noting that the F9Q 1.9 engine has a few variations, and the Di and DCi have differing teeth counts on the timing pulleys. The correct pulley wa...

...e system sheared teeth – caused by incorrect tension and misalignment (fitting error), or the recommended change point has been exceeded Cracked back – caused by heat exposure and/or change point exceeded Side wear/polishing – caused by misalignment (fitting error) Worn teeth fla...

...e system sheared TEETH CAUSE: Fitting error: - Incorrect tension - Misalignment Change point exceeded WORN TOOTH FLANKS CAUSE: Fitting error: - Incorrect (excessive) tension - Misalignment Change point exceeded MARKED BELT BACK CAUSE: Fitting error: - Incorrect tension / al...

...have been sheared off the timing belt, the tensioner pulley arrester body is torn and the full load stop is incorporated. Cause: During the tensioning procedure, the hole in the tension indicator is brought into contact with the hole in the arrester body. As a result, the tension is se...

...have been sheared off the timing belt, the tensioner pulley arrester body is torn and the full load stop is incorporated. Cause: During the tensioning procedure, the hole in the tension indicator is brought into contact with the hole in the arrester body. As a result, the...



1 | 2
footerlogo
popup